KSZ8862-16_10 Datasheet, PDF (113/125 Pages) Micrel Semiconductor – 2-Port Ethernet Switch with Non-PCI Interface and Fiber Support

Micrel, Inc.
Asynchronous Timing Using DATACSN
DATACSN
Read Data
RDN, WRN
Write Data
ARDY
(Read Cycle)
ARDY
(Write Cycle)
t1
t7
t2
valid
t5
t4
t6
valid
t3
t9
t8
t10
Figure 16. Asynchronous Cycle – Using DATACSN
KSZ8862-16/32MQL
Symbol Parameter
Min Typ Max Unit
t1
DATACSN setup to RDN, WRN active
2
ns
t2
DATACSN hold after RDN, WRN inactive (assume
0
ns
ADSN tied Low)
t3
Read data hold to ARDY rising
0.8
ns
t4
Read data to RDN hold
4
ns
t5
Write data setup to WRN inactive
4
ns
t6
Write data hold after WRN inactive
2
ns
t7
Read active to ARDY Low
8
ns
t8
Write inactive to ARDY Low
8
ns
t9
ARDY low (wait time) in read cycle (Note1)
0
40
ns
(It is 0ns to read bank select register and 40ns to
read QMU data register in turbo mode) (Note2)
ARDY low (wait time) in read cycle (Note1)
0
80
ns
(It is 0ns to read bank select register and 80ns to
read QMU data register in normal mode)
t10 ARDY low (wait time) in write cycle (Note1)
0
50
ns
(It is 0ns to write bank select register)
(It is 36ns to write QMU data register)
Note 1: When CPU finished current Read or Write operation, it can do next Read or Write operation even the
ARDY is low. During Read or Write operation if the ADRY is low, the CPU has to keep the RDN/WRN low until
the ARDY returns to high.
Note2: In order to speed up the ARDY low time to 40 ns, user has to use the turbo software driver which is only
supported in the A6 device. Please refer to the “KSZ88xx Programmer's Guide” for detail.
Table 26. Asynchronous Cycle using DATACSN Timing Parameters
August 2010
113
M9999-081310-3.1