DS1682 Datasheet, PDF (5/14 Pages) Dallas Semiconductor – Total Elapsed Time Recorder with Alarm

DS1682
Pin Configuration
Total-Elapsed-Time Recorder
with Alarm
TOP VIEW
+
EVENT 1
N.C. 2
DS1682
ALARM 3
GND 4
SO
(150 mils)
8 VCC
7 N.C.
6 SDA
5 SCL
Pin Description
PIN
NAME
FUNCTION
Event Input. The EVENT pin is the input the DS1682 monitors to determine when an event occurs. When
the pin is pulled high, the contents of the EEPROM are transferred to the ETC and the oscillator starts.
The ETC begins to count in quarter-second increments. When the EVENT pin falls to logic 0, the event
1
EVENT counter increments, and the event counter, ETC, and user-memory data are stored in the EEPROM array.
When the EVENT pin changes states, the 2-wire bus is unavailable for communications for t_EW (falling)
and t_ER (rising). The EVENT input is also deglitched (t_G) to prevent short noise spikes from triggering an
event.
2, 7
N.C. No Connection. These pins are not connected internally.
Active-Low Alarm Output. The DS1682 monitors the values in the ETC for the programmed value in
3
ALARM
the alarm register. When the ETC matches the alarm value, the alarm flag (AF) is set. Once set, the
alarm flag cannot be reset. See the operating descriptions for the AOS and AP bits for details about the
operation of the ALARM pin.
4
GND Ground
5
SCL
2-Wire Serial-Clock Input. The SCL pin is the serial-clock input for the 2-wire synchronous
communications channel. The SCL pin is an input that requires an external pullup resistor.
6
SDA
2-Wire Input/Output. The SDA pin is the data input/output signal for the 2-wire synchronous
communications channel. The SDA pin is an open-drain I/O, which requires an external pullup resistor.
8
V_CC +2.5V to +5.5V Input Supply
www.maximintegrated.com
Maxim Integrated │  5