MAX3394E Datasheet, PDF (4/20 Pages) Maxim Integrated Products – ±15kV ESD-Protected, High-Drive Current, Dual-/Quad-/ Octal-Level Translators with Speed-Up Circuitry

±15kV ESD-Protected, High-Drive Current, Dual-/Quad-/
Octal-Level Translators with Speed-Up Circuitry
TIMING CHARACTERISTICS
(V_CC = +1.65V to +5.5V, V_L = +1.2V to V_CC; C_IOVL ≤ 15pF, C_IOVCC ≤ 15pF; T_A = -40°C to +85°C, unless otherwise noted. Typical val-
ues are at T_A = +25°C.) (Note 1)
PARAMETER
SYMBOL
CONDITIONS
MIN TYP MAX UNITS
I/O V_CC_ Rise Time
t_RVCC
Push-pull driver, Figure 1
Open-drain driver, internal pullup, Figure 2
50
ns
500
I/O V_CC_ Fall Time
t_FVCC
Push-pull driver, Figure 1
Open-drain driver, internal pullup, Figure 2
50
ns
50
I/O V_L_ Rise Time
Push-pull driver, Figure 3
t_RVL
Open-drain driver, internal pullup, Figure 4
50
ns
500
I/O V_L_ Fall Time
Push-pull driver, Figure 3
t_FVL
Open-drain driver, internal pullup, Figure 4
50
ns
50
Propagation Delay
t_I/OVL-VCC
t_I/OVCC-VL
Push-pull driver, Figure 1
Open-drain driver, internal pullup, Figure 2
Push-pull driver, Figure 3
Open-drain driver, internal pullup, Figure 4
50
600
ns
50
600
Propagation Delay After EN
Channel-to-Channel Skew
t_EN
t_SKEW
Push-pull or open-drain driver, Figure 5
Push-pull driver
Open-drain driver, internal pullup
5
µs
5
ns
100
Maximum Data Rate
Push-pull driver, Figures 1, 3
Open-drain driver, internal pullup,
Figures 2, 4
6
Mbps
1
Note 1: All units are 100% production tested at T_A = +25°C. Limits over the operating temperature range are guaranteed by design
and not production tested.
Note 2: During a low-to-high transition, the threshold at which the I/O changes state is the lower of V_ILL and V_ILC since the two sides
are internally connected by an internal switch while the device is in the logic-low state.
4 _______________________________________________________________________________________