MAX1632AEAI Datasheet, PDF (2/29 Pages) Maxim Integrated Products – Multi-Output, Low-Noise Power-Supply Controllers for Notebook Computers

Multi-Output, Low-Noise Power-Supply
Controllers for Notebook Computers
ABSOLUTE MAXIMUM RATINGS
V+ to GND ..............................................................-0.3V to +36V
PGND to GND.....................................................................±0.3V
VL to GND ................................................................-0.3V to +6V
BST3, BST5 to GND ...............................................-0.3V to +36V
LX3 to BST3..............................................................-6V to +0.3V
LX5 to BST5..............................................................-6V to +0.3V
REF, SYNC, SEQ, STEER, SKIP, TIME/ON5,
SECFB, RESET to GND .......................................-0.3V to +6V
V_DD to GND ............................................................-0.3V to +20V
RUN/ON3, SHDN to GND.............................-0.3V to (V+ + 0.3V)
12OUT to GND ...........................................-0.3V to (V_DD + 0.3V)
DL3, DL5 to PGND........................................-0.3V to (VL + 0.3V)
DH3 to LX3 ...............................................-0.3V to (BST3 + 0.3V)
DH5 to LX5 ...............................................-0.3V to (BST5 + 0.3V)
VL, REF Short to GND ................................................Momentary
12OUT Short to GND..................................................Continuous
REF Current...........................................................+5mA to -1mA
VL Current.........................................................................+50mA
12OUT Current ...............................................................+200mA
V_DD Shunt Current ............................................................+15mA
Operating Temperature Ranges
MAX163_ACAI ....................................................0°C to +70°C
MAX163_AEAI .................................................-40°C to +85°C
Storage Temperature Range .............................-65°C to +160°C
Continuous Power Dissipation (T_A = +70°C)
SSOP (derate 9.52mW/°C above +70°C) ....................762mW
Lead Temperature (soldering, 10s) .................................+300°C
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
ELECTRICAL CHARACTERISTICS
(V+ = 15V, both PWMs on, SYNC = VL, VL load = 0mA, REF load = 0mA, SKIP = 0V, T_A = T_MIN to T_MAX, unless otherwise noted.
Typical values are at T_A = +25°C.)
PARAMETER
MAIN SMPS CONTROLLERS
Input Voltage Range
3V Output Voltage in
Adjustable Mode
CONDITIONS
V+ = 4.2V to 30V, CSH3–CSL3 = 0V,
CSL3 tied to FB3
MIN TYP MAX UNITS
4.2
30.0
V
2.42
2.5
2.58
V
3V Output Voltage in Fixed Mode
V+ = 4.2V to 30V, 0mV < CSH3–CSL3 < 80mV,
FB3 = 0V
3.20 3.39 3.47
V
5V Output Voltage in
Adjustable Mode
V+ = 4.2V to 30V, CSH5–CSL5 = 0V,
CSL5 tied to FB5
2.42
2.5
2.58
V
5V Output Voltage in Fixed Mode
Output Voltage Adjust Range
Adjustable-Mode Threshold Voltage
Load Regulation
Line Regulation
Current-Limit Threshold
Idle Mode Threshold
V+ = 5.2V to 30V, 0mV < CSH–CSL5 < 80mV,
FB5 = 0V
Either SMPS
Dual Mode comparator
Either SMPS, 0V < CSH_- CSL_ < 80mV
Either SMPS, 5.2V < V+ < 30V
CSH3–CSL3 or CSH5–CSL5
SKIP = VL or V_DD < 13V or SECFB < 2.44V
SKIP = 0V, not tested
4.85 5.13 5.25
V
REF
5.5
V
0.5
1.1
V
-2
%
0.03
%/V
80
100
120
mV
-50 -100 -150
10
25
40
mV
Soft-Start Ramp Time
Oscillator Frequency
Maximum Duty Factor
From enable to 95% full current limit with respect to
f_OSC (Note 1)
512
Clks
SYNC = VL
SYNC = 0V
270
300
330
kHz
170
200
230
SYNC = VL
SYNC = 0V (Note 2)
97
98
%
98
99
2 _______________________________________________________________________________________