 English |
|
|
|
|
|
|
|
| MAX1458 Datasheet, PDF (2/20 Pages) Maxim Integrated Products – 1%-Accurate, Digitally Trimmed Sensor Signal Conditioner | |||
| |||
| ◁ |
1%-Accurate, Digitally Trimmed
Sensor Signal Conditioner
ABSOLUTE MAXIMUM RATINGS
Supply Voltage, VDD to VSS......................................-0.3V to +6V
All Other Pins ...................................(VSS - 0.3V) to (VDD + 0.3V)
Short-Circuit Duration, FSOTC, OUT, BDRIVE ...........Continuous
Continuous Power Dissipation (TA = +70°C)
SSOP (derate 8.00mW/°C above +70°C) .....................640mW
Operating Temperature Ranges
MAX1458CAE ......................................................0°C to +70°C
MAX1458AAE .................................................-40°C to +125°C
Storage Temperature Range .............................-65°C to +160°C
Lead Temperature (soldering, 10sec) .............................+300°C
Stresses beyond those listed under âAbsolute Maximum Ratingsâ may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
ELECTRICAL CHARACTERISTICS
(VDD = +5V, VSS = 0, TA = +25°C, unless otherwise noted.)
PARAMETER
SYMBOL
CONDITIONS
GENERAL CHARACTERISTICS
Supply Voltage
Supply Current
ANALOG INPUT (PGA)
VDD
IDD (Note 1)
Input Impedance
Input-Referred Offset Tempco
RIN
(Notes 2, 3)
Amplifier Gain Nonlinearity
Output Step Response
63% of final value
Common-Mode Rejection Ratio CMRR From VSS to VDD
Input-Referred Adjustable Offset
Range
At minimum gain (Note 4)
Input-Referred Adjustable FSO
Range
ANALOG OUTPUT (PGA)
Differential Signal-Gain Range
Minimum Differential Signal Gain
Differential Signal-Gain Tempco
Output Voltage Swing
(Note 5)
Selectable in eight steps
TA = TMIN to TMAX
VLIMIT = 5.0V, no load
VLIMIT = 4.6V
10k⦠load to VSS
or VDD
No load
Output Current Range
VLIMIT = 4.6V,
VOUT = (VSS + 0.25V) to (VLIMIT - 0.3V)
Output Noise
DC to 10Hz (gain = 41,
source impedance = 5kâ¦)
MIN
TYP MAX UNITS
4.5
5.0
5.5
V
3
6
mA
1
±0.5
0.01
1
90
±150
Mâ¦
µV/°C
%VDD
ms
dB
mV
10 to 40
mV/V
41 to 230
V/V
36
41
45
V/V
±50
ppm/°C
VSS + 0.15
VDD - 0.25
VSS + 0.25
VLIMIT ± 0.3
V
VSS + 0.1
-0.45
(sink)
VLIMIT ± 0.2
0.45
(source)
mA
500
µVRMS
2 _______________________________________________________________________________________
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese