MAX1061 Datasheet, PDF (15/20 Pages) Maxim Integrated Products – 250ksps, +3V, 8-/4-Channel, 10-Bit ADCs with +2.5V Reference and Parallel Interface

250ksps, +3V, 8-/4-Channel, 10-Bit ADCs
with +2.5V Reference and Parallel Interface
Table 4. Channel Selection for Pseudo-Differential Operation (SGL/DIF = 0)
A2
A1
A0
CH0
CH1
CH2
CH3
CH4*
CH5*
CH6*
0
0
0
+
-
0
0
1
-
+
0
1
0
+
-
0
1
1
-
+
1
0
0
+
-
1
0
1
-
+
1
1
0
+
1
1
1
-
*Channels CH4–CH7 apply to MAX1061 only.
CH7*
-
+
Applications Information
Power-On Reset
When power is first applied, internal power-on reset cir-
cuitry activates the MAX1061/MAX1063 in external
clock mode and sets INT high. After the power supplies
stabilize, the internal reset time is 10µs, and no conver-
sions should be attempted during this phase. When
using the internal reference, 500µs are required for
V_REF to stabilize.
Internal and External Reference
The MAX1061/MAX1063 can be used with an internal
or external reference voltage. An external reference
can be connected directly to REF or REFADJ.
An internal buffer is designed to provide +2.5V at REF for
both the MAX1061 and the MAX1063. The internally
trimmed +1.22V reference is buffered with a +2.05V/V
gain.
Table 5. Data-Bus Output (8 + 2 Parallel
Interface)
PIN HBEN = 0
D0 Bit 0 (LSB)
HBEN = 1
Bit 8
D1
Bit 1
Bit 9 (MSB)
BIPOLAR
(UNI/BIP = 0)
UNIPOLAR
(UNI/BIP = 1)
D2
Bit 2
Bit 9
0
D3
Bit 3
Bit 9
0
D4
Bit 4
Bit 9
0
D5
Bit 5
Bit 9
0
D6
Bit 6
Bit 9
0
D7
Bit 7
Bit 9
0
Internal Reference
With the internal reference, the full-scale range is +2.5V
with unipolar inputs and ±1.25V with bipolar inputs. The
internal reference buffer allows for small adjustments
(±100mV) in the reference voltage (Figure 7).
Note: The reference buffer must be compensated with
an external capacitor (4.7µF min) connected between
REF and GND to reduce reference noise and switching
spikes from the ADC. To further minimize noise on the
reference, connect a 0.01µF capacitor between
REFADJ and GND.
External Reference
With both the MAX1061 and MAX1063, an external ref-
erence can be placed at either the input (REFADJ) or
the output (REF) of the internal reference buffer amplifier.
Using the REFADJ input makes buffering the external
reference unnecessary. The REFADJ input impedance
is typically 17kΩ.
V_DD = +3V
50kΩ
50kΩ
330kΩ
GND
0.01µF
4.7µF
MAX1061
MAX1063
REFADJ
REF
GND
Figure 7. Reference Voltage Adjustment with External
Potentiometer
______________________________________________________________________________________ 15