MAX13325_12 Datasheet, PDF(12/21 Page) Maxim Integrated Products – Dual Automotive, Audio Line Drivers with I2C Control and Diagnostic

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

MAX13325_12 Datasheet, PDF (12/21 Pages) Maxim Integrated Products – Dual Automotive, Audio Line Drivers with I2C Control and Diagnostic

◁

MAX13325/MAX13326

Dual Automotive, Audio Line Drivers

with I2C Control and Diagnostic

Table 7. Flag Register Format

FLAG Register

ADDRESS

FUNCTION

CODE

(HEX)

POR STATE

D2 D1 D0

(HEX)

FLAG

0x05

FLAG LHIGHZ RHIGHZ OFFSETL OFFSETR ID2 ID1 ID0 0x04/0x05

FLAG: FLAG bit is set to â1â when the FLAG output is logic-low. The FLAG bit allows to quickly access the status of the

device without using the FLAG output and without having to read all the fault registers.

LHIGHZ: The LHIGHZ bit is set to â1â when the left-channel output is high impedance; for example due to a short circuit.

RHIGHZ: The RHIGHZ bit is set to â1â when the right-channel output is high impedance; for example due to a short

circuit.

OFFSETL: The OFFSETL bit is set to â1â when excessive offset is detected on the left-channel output.

OFFSETR: The OFFSETR bit is set to â1â when excessive offset is detected on the right-channel output.

ID[2:0]: The ID[2:0] bits indicate the device type (12dB = 100 and 0dB = 101).

Table 8. General Mask Register Format

General Mask Register

ADDRESS

FUNCTION

CODE

(HEX)

POR STATE

D3 D2 D1 D0

(HEX)

General Mask

0x06

0 MTWARN MTSHDN MDUMP

0x00

MTWARN: Set MTWARN to â1â to enable the TWARN fault detection. See Table 4.

MTSHDN: Set MTSHDN to â1â to enable the TSHDN fault detection. See Table 4.

MDUMP: Set MDUMP to â1â to enable the DUMP fault detection. See Table 4.

Table 9. Left-Channel Mask Register

ADDRESS

FUNCTION

CODE

(HEX)

Left-Channel Mask Register

POR

STATE

D1 D0 (HEX)

Left-Channel

Mask Register

0x07

MSVDDL MSGNDL MLIMITL 0 MOFFSETL MOPENL x x

0x00

MSVDDL: Set MSVDDL to 1 to enable the short to VDD detection on the left channel.

MSGNDL: Set MSGNDL to 1 to enable the short to GND detection on the left channel.

MLIMITL: Set MLIMITL to 1 to enable overcurrent detection on the left channel.

MOFFSETL: Set MOFFSETL to 1 to enable excessive-offset detection on the left-channel output.

MOPENL: Set MOPENL to 1 to enable open-load detection on the left channel.

12ââ

Maxim Integrated

▷