MAX1182 Datasheet, PDF (11/21 Pages) Maxim Integrated Products – Dual 10-Bit, 65Msps, +3V, Low-Power ADC with Internal Reference and Parallel Outputs

Dual 10-Bit, 65Msps, +3V, Low-Power ADC with
Internal Reference and Parallel Outputs
Detailed Description
The MAX1182 uses a 9-stage, fully-differential
pipelined architecture (Figure 1) that allows for high-
speed conversion while minimizing power consump-
tion. Samples taken at the inputs move progressively
through the pipeline stages every half clock cycle.
Counting the delay through the output latch, the clock-
cycle latency is five clock cycles.
1.5-bit (2-comparator) flash ADCs convert the held-
input voltages into a digital code. The digital-to-analog
converters (DACs) convert the digitized results back
into analog voltages, which are then subtracted from
the original held input signals. The resulting error sig-
nals are then multiplied by two and the residues are
passed along to the next pipeline stages where the
process is repeated until the signals have been
processed by all nine stages. Digital error correction
compensates for ADC comparator offsets in each of
these pipeline stages and ensures no missing codes.
Input Track-and-Hold (T/H) Circuits
Figure 2 displays a simplified functional diagram of the
input track-and-hold (T/H) circuits in both track and
hold mode. In track mode, switches S1, S2a, S2b, S4a,
S4b, S5a and S5b are closed. The fully-differential cir-
cuits sample the input signals onto the two capacitors
(C2a and C2b) through switches S4a and S4b. S2a and
S2b set the common mode for the amplifier input, and
open simultaneously with S1, sampling the input wave-
form. Switches S4a and S4b are then opened before
switches S3a and S3b, connect capacitors C1a and
C1b to the output of the amplifier, and switch S4c is
closed. The resulting differential voltages are held on
capacitors C2a and C2b. The amplifiers are used to
charge capacitors C1a and C1b to the same values
originally held on C2a and C2b. These values are then
presented to the first-stage quantizers and isolate the
pipelines from the fast-changing inputs. The wide input
bandwidth T/H amplifiers allow the MAX1182 to track-
and-sample/hold analog inputs of high frequencies (>
Nyquist). The ADC inputs (INA+, INB+, INA-, and INB-)
can be driven either differentially or single-ended.
Match the impedance of INA+ and INA- as well as
INB+ and INB- and set the common-mode voltage to
mid-supply (V_DD/2) for optimum performance.
V_IN
T/H
Σ
x2
V_OUT
V_IN
T/H
Σ
x2
V_OUT
FLASH
ADC
DAC
1.5 BITS
STAGE 1
STAGE 2
STAGE 8
2-BIT FLASH
ADC
STAGE 9
FLASH
ADC
DAC
1 5 BITS
STAGE 1
STAGE 2
STAGE 8
2-BIT FLASH
ADC
STAGE 9
T/H
V_INA
DIGITAL CORRECTION LOGIC
10
DIGITAL CORRECTION LOGIC
T/H
10
D9A–D0A
V_INB
V_INA = INPUT VOLTAGE BETWEEN INA+ AND INA- (DIFFERENTIAL OR SINGLE-ENDED)
V_INB = INPUT VOLTAGE BETWEEN INB+ AND INB- (DIFFERENTIAL OR SINGLE-ENDED)
D9B–D0B
Figure 1. Pipelined Architecture—Stage Blocks
______________________________________________________________________________________ 11