MAX1112 Datasheet, PDF (11/20 Pages) Maxim Integrated Products – 5V, Low-Power, Multi-Channel, Serial 8-Bit ADCs Internal 4.096V Reference

+5V, Low-Power, Multi-Channel,
Serial 8-Bit ADCs
Table 4. Full-Scale and Zero-Scale Voltages
UNIPOLAR MODE
Full Scale
Zero Scale
V_REFIN + COM
COM
Positive
Full Scale
+V_REFIN/2
+ COM
BIPOLAR MODE
Zero
Scale
COM
Negative
Full Scale
-V_REFIN/2
+ COM
in control bytes of $FF (hex), which trigger single-
ended, unipolar conversions on CH7 (MAX1112) or
CH3 (MAX1113) in external clock mode without power-
ing down between conversions. In external clock mode,
the SSTRB output pulses high for two clock periods
before the most significant bit (MSB) of the 8-bit con-
version result is shifted out of DOUT. Varying the ana-
log input alters the output code. A total of 10 clock
cycles is required per conversion. All transitions of the
SSTRB and DOUT outputs occur on SCLK’s falling
edge.
How to Start a Conversion
A conversion is started by clocking a control byte into
DIN. With CS low, each rising edge on SCLK clocks a bit
from DIN into the MAX1112/MAX1113’s internal shift reg-
ister. After CS falls, the first arriving logic “1” bit at DIN
defines the MSB of the control byte. Until this first start bit
arrives, any number of logic “0” bits can be clocked into
DIN with no effect. Table 3 shows the control-byte format.
The MAX1112/MAX1113 are compatible with
MICROWIRE, SPI, and QSPI devices. For SPI, select the
correct clock polarity and sampling edge in the SPI con-
trol registers: set CPOL = 0 and CPHA = 0. MICROWIRE,
SPI, and QSPI all transmit a byte and receive a byte at the
same time. Using the Typical Operating Circuit (Figure 3),
the simplest software interface requires three 8-bit trans-
fers to perform a conversion (one 8-bit transfer to config-
ure the ADC, and two more 8-bit transfers to clock out the
0V TO
+4.096V
ANALOG _0.01µF
INPUT
C1
1µF
V_DD
DGND
MAX1112
MAX1113
CH7 (CH3)
AGND
CS
COM
REFOUT
REFIN
SCLK
DIN
SSTRB
DOUT
SHDN
0.1µF
+5V
N.C.
+5V
1µF
500kHz
OSCILLATOR
OSCILLOSCOPE
SCLK
SSTRB
DOUT*
CH1
CH2
CH3
CH4
*FULL-SCALE ANALOG INPUT, CONVERSION RESULT = $FF (HEX)
( ) ARE FOR THE MAX1113.
Figure 5. Quick-Look Circuit
______________________________________________________________________________________ 11