MAX1652 Datasheet, PDF (10/28 Pages) Maxim Integrated Products – High-Efficiency, PWM, Step-Down DC-DC Controllers in 16-Pin QSOP

High-Efficiency, PWM, Step-Down
DC-DC Controllers in 16-Pin QSOP
Standard Application Circuits
It’s easy to adapt the basic MAX1653 single-output 3.3V
buck converter (Figure 1) to meet a wide range of appli-
cations with inputs up to 30V (limited by choice of exter-
nal MOSFET). Simply substitute the appropriate
components from Table 1 (candidate suppliers are pro-
vided in Table 2). These circuits represent a good set of
trade-offs among cost, size, and efficiency while staying
within the worst-case specification limits for stress-relat-
ed parameters such as capacitor ripple current.
Don’t change the frequency of these circuits without
first recalculating component values (particularly induc-
tance value at maximum battery voltage).
For a discussion of dual-output circuits using the
MAX1652 and MAX1654, see Figure 9 and the
Secondary Feedback-Regulation Loop section.
Detailed Description
The MAX1652 family are BiCMOS, switch-mode power-
supply controllers designed primarily for buck-topology
regulators in battery-powered applications where high
efficiency and low quiescent supply current are critical.
The parts also work well in other topologies such as
boost, inverting, and Cuk due to the flexibility of their
floating high-speed gate driver. Light-load efficiency is
enhanced by automatic idle-mode operation—a vari-
able-frequency pulse-skipping mode that reduces
losses due to MOSFET gate charge. The step-down
power-switching circuit consists of two N-channel
MOSFETs, a rectifier, and an LC output filter. The out-
put voltage is the average of the AC voltage at the
switching node, which is adjusted and regulated by
changing the duty cycle of the MOSFET switches. The
gate-drive signal to the N-channel high-side MOSFET
must exceed the battery voltage and is provided by a
flying capacitor boost circuit that uses a 100nF capaci-
tor connected to BST.
INPUT
C1
C7
0.1µF
10
11
V+
VL
D2
CMPSH-3
C4
4.7µF
6
ON/OFF
SHDN
DH ¹⁶
Q1
CONTROL
BST ¹⁴
C3
LOW-NOISE
CONTROL
2
SKIP
MAX1653
LX ¹⁵
0.1µF
L1
R1
DL ¹³
Q2
D1
1
SS
C6
0.01µF
(OPTIONAL)
FB
7
NOTE: KEEP CURRENT-SENSE
LINES SHORT AND CLOSE
TOGETHER. SEE FIGURE 8.
PGND ¹²
SYNC
5
8
CSH
9
CSL
4
GND
3
REF
J1
150kHz/300kHz
JUMPER
C5
0.33µF
Figure 1. Standard 3.3V Application Circuit (see Table 1 for Component Values)
+5V AT
5mA
+3.3V
OUTPUT
C2
GND
OUT
REF OUTPUT
+2.5V AT 100µA
10 ______________________________________________________________________________________