6014CT Datasheet, PDF (7/8 Pages) Mallory performance club – MSD Circle Track LS Ignition Control

INSTALLATION INSTRUCTIONS
7
Figure 5 Custom Timing Table 1
MONITORS
MONITORS
ENGINE SPEED
IGNITION TIMING
IGNITION VOLTAGE
REV LIMITER SOURCE
Description
Engine speed in RPM
Ignition timing referenced to Top Dead Center (TDC)
This is the voltage being supplied to the unit. This is also the voltage
being supplied to the coils - so it is important that it remains over 12V to
ensure optimum engine performance.
Indicates which source will be limiting the motor. It will be "Key Off" when
connected via USB, or "Maximum" any other time.
ALERTS
FAULTS
BATTERY
CAM FAULT
CRANK FAULT
EEPROM READ ERROR
EEPROM WRITE ERROR
Description/Cause
Activates if voltage drops below 9V or goes above 18V
RPM is detected, but no cam sensor signal is present
Camshaft sensor signal is present, but no engine speed is detected via
the crankshaft sensor.
EEPROM data corrupted
Error writing to EEPROM
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]