6014CT Datasheet, PDF (5/8 Pages) Mallory performance club – MSD Circle Track LS Ignition Control

INSTALLATION INSTRUCTIONS
5
RELAY - 30A MINIMUM RATING
FUSED (30A)
BATTERY
30
GROUND
30
85
86
87a
87
KEYED 12V
TO 6014CT IGNITION WIRE (RED)
Figure 3 Recommended Relay Set-Up for supplying MaiN 12V Power
RACE IGNITION TOOL
The MSD Racing Ignition Test Tool, (PN 89973) was developed
to help sanctioning bodies verify the compliance/configuration
of MSD products. The Test Tool communicates with MSD
products via the Diagnostic Connector.
MSD products that are compatible with the Test Tool will have a
dedicated tab in the MSDView software named "REGULATED".
Any unit can be configured as a MASTER unit, The Test Tool can
then be connected to the MASTER unit and the REGULATED
parameters synced to the MASTER configuration in the tool,
The Test Tool with the MASTER configuration can then be used
to verify the compliance of units in the field.
MOUNTING
Figure 4 PN 89973 Race Ignition Test Tool
PN 6014 CT LS Ignition Controller must be mounted in a sturdy,
dry location and not exposed to extreme heat. It should be
mounted using the included rubber isolators to protect it from
excessive vibration. The unit is fully potted, but should not be immersed or subjected to direct spray
from a power washer.
MSDVIEW
The MSDView software allows calibration of control parameters such as ignition timing, rev limiter and
also live monitoring of engine. The following information gives a brief explanation of each function or
feature in the system and the settings that control them. While using the software, you can mouse
over each item for a brief on-screen explanation.
Note: Make sure MSDView is installed on the PC prior to connecting the Circle Track LS Ignition
Controller.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]