6010 Datasheet, PDF (3/8 Pages) Schurter Inc. – IEC Appliance Inlet C14, Snap-in Mounting, Front Side, Solder or Quick-connect or Screw-on Terminal

INSTALLATION INSTRUCTIONS
3
2-PIN CONNECTOR, ACCESSORIES
PINK
Pin-A Step Retard. When 12-volts are supplied, the Sw Retard is activated.
BLUE
Pin-B Two-Step. When 12-volts are supplied, the RevLO rpm value is active.
16-PIN CONNECTOR WIRE LOCATION
GRAY
Pin-A Ground
PINK
Pin-B 12 Volt Supply
BROWN/WHITE Pin-C Cam Sensor Signal
RED/GREEN
Pin-D Coil-2
BROWN/GREEN Pin-E Coil-4
WHITE/BLUE
Pin-F Coil-6
VIOLET/BLUE
Pin-G Coil-8
YELLOW
Pin-H Tach
BROWN
Pin-J Sensor Ground
LT. GREEN
Pin-K MAP Sensor Signal
RED
Pin-L Coil-7
GREEN
Pin-M Coil-5
LT. BLUE
Pin-N Coil-3
VIOLET
Pin-P Coil-1
ORANGE/YELLOW Pin-R Crank Sensor Signal
ORANGE
Pin-S 5 Volt Supply
Figure 1 Wiring the MSD Gen III Controller.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]