6010 Datasheet, PDF (2/8 Pages) Schurter Inc. – IEC Appliance Inlet C14, Snap-in Mounting, Front Side, Solder or Quick-connect or Screw-on Terminal

2
INSTALLATION INSTRUCTIONS
LOOSE WIRES
BLACK/GRAY
Pin-A/B Ground. Connect to a ground source, such as the engine or battery negative.
PINK
Pin-C On/Off wire. Connect to a switched 12 volt source.
YELLOW
Tach Signal. Provides a 12 volt square wave signal.
CRANKSHAFT SENSOR, 3-PIN
ORANGE/YELLOW Pin-A Crank Sensor Signal
BROWN
Pin-B Sensor Ground
PINK
Pin-C 12 Volt Supply
CAMSHAFT SENSOR, 3-PIN
BROWN/WHITE Pin-A Cam Sensor Signal
BROWN
Pin-B Sensor Ground
PINK
Pin-C 12 Volt Supply
MAP CONNECTOR, 3-PIN (OPTIONAL)
BROWN
Pin-A Sensor Ground
LT. GREEN
Pin-B MAP Sensor Signal
ORANGE
Pin-C 5 Volt Supply
COIL CONNECTOR, CYLINDERS 2, 4, 6, 8
BLACK
Pin-A Ground
RED/GREEN
Pin-B Coil-2
BROWN/GREEN Pin-C Coil-4
BROWN
Pin-E Sensor Ground
WHITE/BLUE
Pin-F Coil-6
VIOLET/BLUE
Pin-G Coil-8
PINK
Pin-H 12 Volt Supply
Note: Pin-D is not used
COIL CONNECTOR, CYLINDERS 1, 3, 5, 7
BLACK
Pin-A Ground
RED
Pin-B Coil-7
GREEN
Pin-C Coil-5
BROWN
Pin-E Sensor Ground
LT. BLUE
Pin-F Coil-3
VIOLET
Pin-G Coil-1
PINK
Pin-H 12 Volt Supply
Note: Pin-D is not used
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]