6010 Datasheet, PDF (1/8 Pages) Schurter Inc. – IEC Appliance Inlet C14, Snap-in Mounting, Front Side, Solder or Quick-connect or Screw-on Terminal

MSD LS-1/LS-6 Controller
for Carbureted and EFI Gen III Engines
PN 6010
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
Parts Included
1 – Ignition Controller, PN 6010
1 – Pro-Data+ Software CD
1 – Harness
1 – Parts Bag
6 – Timing Modules
Optional Accessories
Hand Held Monitor, PN 7550
Harness for Intake Mounting, PN 60101
Factory EFI Harness, PN 8886
WARNING: During installation, disconnect the battery cables. When Disconnecting, always remove
the Negative cable first and install it last.
Note: Solid core spark plug wires or non-resistor spark plugs cannot be used with an MSD Ignition
Control.
CARBURETOR
The PN 6010 Ignition Controller is designed for GM Gen III engines that have been retro-fit with an
intake manifold and carburetor. The Controller can also be used in stock, EFI applications, by using
accessory Harness PN 8886. The factory coils or MSD Coil, PN 8245, must be used. The Controller
is supplied with a wiring harness that connects to the factory connectors for a simple installation. A
shorter harness designed for mounting the unit on the intake manifold is available as PN 60101.
EFI
This Controller can also be used in stock, EFI applications, by using accessory Harness PN 8886.
This Harness allows the PN 6010 Controller to tap into the sensor signals without interrupting the OEM
ECU. The ECU and coils operate as normal while the PN 6010 controls the timing and rpm.
OPERATION
The MSD Controller offers several programmable features that allow rpm and timing adjustments. This
can be achieved through the supplied Pro-Data+ software via a PC or with the optional Hand Held
Programmer, PN 7550. Timing adjustments and selections can also be made with plug-in modules.
Software installation, operation and the programmable features of the Controller are explained in detail
in this document. More information can be found in the Pro-Data+ Software Help section.
MOUNTING
The Controller is designed to be mounted under the hood or on the firewall. Do not mount the unit
near exhaust, upside down or seal the base as that leaves no way for any moisture to escape the
unit. Four vibration mounts are supplied to mount the unit. Find a suitable location, confirm that all
of the wires reach their connections. Mark the mounting hole locations using the unit. Drill the holes
with a 3/16" bit.
WIRING
All of the wiring, except four wires, are routed into factory style connectors to ensure an easy installation.
The wire descriptions follow in the chart on pages 2 and 3.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]