408-2433 Datasheet, PDF (8/8 Pages) Tyco Electronics – Remove assembly pins from mounting lugs as shown in Figure 1

Insulation Piercing COPALUM Terminal and Splice Crimping Heads
408-2433
7. To meet the NO–GO gage conditions, jaw
bottoming surfaces will NOT bottom, and NO–GO
gage member will be held stationary (will not
rotate) by the dies. See Figure 9, Detail B.
8. Inspect the right and left outer crimp closures in
the same manner as steps (2) thru (7). See Figure
9, Details C and D.
9. If both the inner crimp and the outer crimp
closures meet the GO NO–GO gage conditions,
the die closures may be considered dimensionally
correct. If you find that the die closures do not
conform with the GO NO–GO gage conditions,
contact your local Tyco Electronics Representative.
4.5. Replacement Parts
It may be advantageous to stock certain replaceable
parts to prevent loss of production time. Figure 10
lists the customer replaceable parts that can be
purchased from Tyco Electronics. Order
replacements through your Tyco Electronics
Representative, or call 1–800–526–5142, or send a
facsimile of your purchase order to 717–986–7605, or
write to:
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
5. REVISION SUMMARY
S Updated document to corporate requirements
S New format
See Footnote for Locator Parts Replacement
ITEM
DESCRIPTION
TOOL NUMBERS
QTY
68081
68082
1
LINK
1
1-59649-9
2-59649-0
2
LOWER JAW, with Locators
1
307829-1
307829-2
3
UPPER JAW
1
307792-1
307792-2
4
RING, Retaining
4
1-21048-6
1-21048-6
5
PIN, Retaining
2
300042
300042
6
PIN, Pivot
1
300115
300115
7
LINK
1
300114
300114
8
RING, Retaining
6
300102
300102
9
PIN, Retaining
3
302563
302563
10
LINK, Toggle
2
302562
302562
11
LEVER, Toggle
1
302561
302561
RIVET
D
PLATE, Locator
2
1-59573-5
2
308134-1
1-59573-5
308134-1
LOCATOR
2
308132-1
DIf locators are worn and need replacement, order parts from this area of table.
Figure 10
308132-1
8 of 8
Tyco Electronics Corporation
A Rev