408-2433 Datasheet, PDF (4/8 Pages) Tyco Electronics – Remove assembly pins from mounting lugs as shown in Figure 1

Insulation Piercing COPALUM Terminal and Splice Crimping Heads
408-2433
NOTE
i
Butt splices may be slightly bent when crimped
as instructed in step (4). If this bending is
objectionable, use the following crimping
procedure:
5. To crimp other half of butt splice, remove and
rotate splice 180° end over end. Reposition
uncrimped half in lower jaw as described in step
(1). If splice cannot be rotated, rotate tool. Insert
wire and then crimp the splice.
6. Refer to Section 3 and Figure 5 for crimp
inspection.
C. Parallel Splices
Ensure that wire size stamped on the splice
corresponds with the wire size stamped on the
crimping head link.
1. Position splice between locators as shown in
Figure 4C.
2. Insert wires into splice until ends of wires are
flush with or extended slightly beyond wire barrel.
Hold splice in place, press thumb control and hold
it down until crimping stroke is completed.
Wire Range
Stamped on Bottom
of Tongue
ACCEPT
Terminal
REJECT
Wire Range
Stamped
on Bottom
of Tongue
Parallel Splice
Wire Range
Stamped Here
Butt Splice
Wire Range
Stamped Here
4 of 8
Figure 5
Tyco Electronics Corporation
Rev A