408-8733 Datasheet, PDF (7/7 Pages) Tyco Electronics – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools.

408-8733
6. With the insulation adjustment indicator in
Position 1, measure the insulation crimping
chambers with the proper NO-GO plug gages.
See Figure 8.
If the crimping areas conform to the gage inspection,
the tool is considered dimensionally correct. If the
crimping areas do not conform to the inspection, the
tool must be repaired. Refer to Section 7,
REPLACEMENT.
7. .REPLACEMENT (Figure 9)
These crimping die assemblies are inspected before
shipment. It is recommended that the dies be
inspected immediately upon arrival at your facility to
ensure that the dies have not been damaged during
shipment.
Order replacements through your local Tyco
Electronics representative, or call 1-800-526-5142, or
send a facsimile of your purchase order to 1-717-986-
7605, or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
8. REVISION SUMMARY
Since the previous release of this document, the TE
logo has been applied.
Locator
1583381-
Button Head
Cap Screw
18024-6
Hex Nuts
986965-3
Shoulder
Screws
133877-1
Spring Lock
Washer 18025-2
Shoulder
Screws
133877-1
Spring
Lock
Washer
18025-2
Hex Nuts
986965-3
Figure 9
Rev A
7 of 7