408-8733 Datasheet, PDF (2/7 Pages) Tyco Electronics – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools.

408-8733
TERMINAL OR SPLICE
RIDG (Pre Insulated Diamond Grip Terminal
Wire
Barrel
Insulation
Barrel
SIZE
(AWG)
12-10
WIRE
INSULATION
DIAMETER
RANGE
3.81-6.35 [.150-.250]
Flat
Side
Strip
Length
16-14 HD 3.81-6.35 [.150-.250]
STRIP
LENGTH
±0.397 [±0.16]
CRIMP DOT
CODE
(After Crimping)
1
8.33 [.328]
1
PLASTI-GRIP* Terminal
12-10
3.81-6.35 [.150-.250]
1
Striped Color
Code for HD
8.33 [.328]
Color-Coded
Insulation
16-14 HD 2.67-6.35 [.105-.250]
1
PIDG Insulation Restriction Terminal
12
2.41-55.08 [.095-.200]
1
Equally-Spaced
Shaded Stripes
9.92 [.391]
10
3.02-5.08 [.119-.200]
1
PIDG Butt Splice
Window Indent
Insulation
12-10
4.32-5.59 [.170-.220]
9.13 [.359]
1
Barrel
Wire Barrel
Figure 2
1. Turn on the SDE 1600 Power Unit and allow
approximately five seconds for the hydraulic
pressure to build up.
5. Insert stripped wire into terminal until wire butts
against locator. Insert stripped wire into splice
until wire butts against wire stop in splice.
2. Open the crimping dies by depressing the
control lever on the power unit.
3. Then position the terminal between the
crimping dies (Figure 4). The terminal is properly
positioned when the tongue of the terminal is
under the locator and the wire barrel is against
the locator,
4. Release the control lever, allowing the dies to
spring shut and hold the terminal in place.
6. Cycle the SDE 1600 Power Unit and hold
momentarily to complete the crimp. The terminal
or splice should be as shown in Figure 5 or
Figure 6
7. Remove the crimped terminal or splice.
8. When crimping a butt splice, reposition the
uncrimped half in the stationary die. It the splice
cannot be turned around turn the tool around,
load stripped wire in splice and cycle the power
unit.
9. Remove the butt splice.
Rev A
2 of 7