408-8731 Datasheet, PDF (7/7 Pages) Tyco Electronics – Turn off the SDE 1600 Power Unit and disconnect it from the power supply.

SDE Crimping Die Assembly 91963-[ ]
GO gage must pass completely
through the die closure.
408-8731
NO-GO gage may enter partially,
but must not pass completely
through the die closure.
Wire Crimp
Insulation
Crimp
Plug Gage for
Wire Crimp
Chamber
Locator Assembly
Removed for Clarity
Plug Gage for Insulation
Crimping Chamber
Figure 8
7. REPLACEMENT (Figure 9)
These crimping die assemblies are inspected before
shipment. It is recommended that the dies be
inspected immediately upon arrival at your facility to
ensure that the dies have not been damaged during
shipment.
Order replacements through your local Tyco
Electronics Representative, or call 1–800–526–5142,
or send a facsimile of your purchase order to
1–717–986–7605, or write to:
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
8. REVISION SUMMARY
S Updated document to corporate requirements
S Corrected wire barrel GO dimensions in table in
Figure 7
Hex Nuts
986965-3
Shoulder
Screws
1338771-1
Spring Lock
Washer
18025-2
Locator
1424096-1
Button Head
Cap Screw
18024-6
Spring Lock
Washer
18025-2
Shoulder
Screws
1338771-1
Figure 9
Hex Nuts
986965-3
Rev A
Tyco Electronics Corporation
7 of 7