408-4366 Datasheet, PDF (7/10 Pages) Tyco Electronics – 626 Pneumatic Crimping Heads

Pneumatic Crimping Heads 662546- 1 and 1320369- 1
408- 4366
4. Align the NO--GO element with the inner
crimping section. Push element straight into the
crimping chamber without using force. The
NO--GO element must pass completely through
the crimping chamber and then must not rotate.
See Figure 7, Detail A.
5. Open the crimping jaws. Position the GO
element on the lower jaw in the right outer crimping
section so that the locator is in the notch of the
element. Close the crimping jaws so that the lower
jaw surface of the crimping chamber is seated on
the element. The GO element must pass
completely through the crimping chamber and then
rotate freely in either direction. See Figure 7,
Detail B.
6. Position the NO--GO element on the lower jaw
in the right outer crimping section so that the
locator is in the notch of the element. Close the
crimping jaws so that the lower jaw surface of the
crimping chamber is seated on the element. The
NO--GO element must pass completely through
the crimping chamber and then must not rotate.
See Figure 7, Detail B.
7. Repeat Steps 5 and 6 for the left outer crimping
section.
If the crimping chamber passes the gage inspection,
the crimping head is considered dimensionally correct
and should be lubricated with a THIN coat of any
good SAE 20 motor oil. If the crimping chamber does
not conform to the plug gage conditions, contact your
local Field Representative or refer to Section 8.
For additional information about the use of a plug
gage, see instruction sheet 408--7424.
8. REPLACEMENT AND REPAIR
Replacement parts and recommended spares are
listed in Figure 8. The recommended spares should
be stocked for immediate replacement.
Order replacement parts through your representative,
or call 1--800--526--5142, or send a facsimile of your
purchase order to 1--717--986--7605, or write to:
CUSTOMER SERVICE (38--35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105--3608
For repair service, please contact a representative at
1--800--526--5136.
9. REVISION SUMMARY
Since the previous release of this document, the
following changes have been made:
S Added “Original Instructions;”
S Applied the TE logo.
Rev C
Tyco Electronics Corporation
7 of 10