408-4366 Datasheet, PDF (1/10 Pages) Tyco Electronics – 626 Pneumatic Crimping Heads

626 Pneumatic Crimping Heads
662546- 1 and 1320369- 1
Instruction Sheet
408- 4366
11 MAR 10 Rev C
Quick
Pin(s)
Rollers
626 Pneumatic
Crimping Head
662546- 1 Shown,
(Ref)
Tool Holder
Assembly
189767- 1 or
356302- 1
Link
Lower
Crimping Jaw
Locator
Product: COPALUM* Terminals and Splices
Wire Size: 8 AWG, Stranded Copper, Film- Insulated
Copper, or Film- Insulated Aluminum
Product Catalog: 82020
Tooling Catalog: 124208
Upper
Crimping Jaw
Guard
Figure 1
1. INTRODUCTION
626 Pneumatic Crimping Heads 662546--1 and
1320369--1 (shown in Figure 1) are designed to crimp
COPALUM terminals, butt splices, and parallel splices
onto wire size 8 AWG. The crimping heads are used
with 626 Pneumatic Tooling Assemblies 189721--2 or
189722--2 when fitted with Tool Holder Assembly
189767--1 or 356302--1.
NOTE
i
Dimensions on this sheet are in metric units
[with U.S. customary units in brackets]. Figures
are not drawn to scale.
Reasons for reissue of this document are provided in
Section 9, REVISION SUMMARY.
2. DESCRIPTION
This instruction sheet provides recommended
procedures for wire preparation, crimping head
installation, crimping, and maintenance and
inspection. For setup and operation of the pneumatic
tools, refer to Customer Manual 409--5862 packaged
with the pneumatic tooling assembly. Read these
instructions thoroughly before proceeding.
Each pneumatic crimping head is designed with
integral jaws which close in an arc--like motion.
To ensure proper crimping head selection, each
crimping head link is stamped with a wire size range
which must correspond with the wire size range
stamped on the terminal or splice.
After an operator locates the terminal or splice
between the crimping jaws and inserts the stripped
E2010 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other product names, logos, or company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 10
LOC B