408-10210 Datasheet, PDF (7/8 Pages) Tyco Electronics – The die assemblies consist of stationary dies and moving dies

Crimping Die Assemblies for COPALUM Sealed Terminals and Splices
408-10210
6. REPLACEMENT AND REPAIR
The parts listed in Figure 7 are customer–
replaceable. A complete inventory can be stocked
and controlled to prevent lost time when replacement
of parts is necessary. Order replacement parts
through your representative, or call 1–800–526–5142,
or send a facsimile of your purchase order to
1–717–986–7605, or write to:
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
Dies may also be returned for evaluation and repair.
For die repair service, contact a representative at
1–800–526–5136.
7. REVISION SUMMARY
S Initial release of document
Inspection of Wire Barrel
Crimp Die Closure
GO" Gage Element Must Pass
Completely Through the Die Closure.
Dies are Bottomed
but Not Under
Pressure
NO-GO" Gage Element May Enter
Partially, but Must Not Pass Completely
Through the Die Closure.
SUGGESTED PLUG GAGE DESIGN Ċ WIRE BARREL CRIMP
Die Closure
Configuration
GO Dim.
C"
B"
Dim.
DIE SET
NUMBER
1490555-1
1490556-1
1490557-1
Rev A
25.4 mm
[1 In.]
Typ.
GAGE ELEMENT DIMENSION B"
GO
NO-GO
2.870-2.877 [.1130-.1133]
3.045-3.048 [.1199-.1200]
3.200-3.208 [.1260-.1263]
3.375-3.378 [.1329-.1330]
3.937-3.944 [.1550-.1553]
4.112-4.114 [.1619-.1620]
Figure 8
R" Radius
NO-GO Dim.
B"
R" RADIUS
(Max.)
3.16 [.125]
3.556 [.140]
4.34 [.171]
C"
DIM.
6.35 [.250]
6.35 [.250]
6.35 [.250]
Tyco Electronics Corporation
7 of 8