408-4199 Datasheet, PDF (6/7 Pages) Tyco Electronics – This instruction sheet covers the application and maintenance procedures for Crimping Die Assembly

Crimping Die Assembly 318106-1
50.8
[2.00]
Min.
Suggested Plug Gage Design - Outer Crimp
M"
K"
408-4199
J"
1/2 J"
N"
GO Dim.
Outer Crimp Die
Closure
Configuration
L" Dia.
NO-GO Dim.
DIE SET
NUMBER
318106-1
GO
11.430 - 11.438
[.4500 - .4503]
NO-GO
GAGE ELEMENT DIMENSIONS
(A" Dia.)
J"
K"
L" Dia.
11.783 - 11.786
[.4639 - .4640]
6.35
[.250]
Figure 7
5.08
[.200]
6.35
[.250]
M"
12.19
[.480]
N"
2.46
[.097]
8. Inspect the right and left outer crimp closures in
the same manner as Steps 2 through 7. See
Figure 8, Details C and D.
If both the inner crimp and the outer crimp closures
meet the plug gage conditions, the die closures may
be considered dimensionally correct and lubricated
with a thin coat of any good SAE 20 motor oil. If the
dies do not conform, the dies must be replaced or
repaired before returning them to service. See
Section 8, REPLACEMENT AND REPAIR.
For additional information concerning the use of the
plug gage, refer to Instruction Sheet 408–7424.
8. REPLACEMENT AND REPAIR (Figure 9)
Order replacements through your representative, or
call 1–800–526–5142, or send a facsimile of your
purchase order to 717–986–7605, or write to:
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
9. REVISION SUMMARY
S Updated document to corporate requirements
S Changed dimension lines in Figures 6 and 7
6 of 7
Tyco Electronics Corporation
Rev A