408-4218 Datasheet, PDF (5/5 Pages) Tyco Electronics – PRO–CRIMPER III Hand Crimping Tool Assembly

PRO-CRIMPER III Hand Crimping Tool Assembly 318450-1
408-4218
8. REPLACEMENT
Customer–replaceable parts and dies are shown in
Figure 7. Spare parts or the die assembly should be
stocked and controlled to prevent lost time when die
replacement is necessary.
Available separately, PRO–CRIMPER III Hand
Crimping Tool Repair Kit 679221–1 includes a
replacement nut and a variety of pins, rings, screws,
and springs.
Order replaceable parts through your Tyco
Electronics Representative, or call 1–800–526–5142,
or send a facsimile of your purchase order to
1–717–986–7605, or write to:
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
9. REVISION SUMMARY
Since the previous release of this instruction sheet,
the following changes were made:
S The TE logo was applied;
S PRO–CRIMPER II became PROCRIMPER III;
S Format was updated to current corporate
requirements
1
1.04-1.17
[.041-.046]
3
2.64 +0.20
[.104 +.008]
4
2
Weight: 227 g [8 oz]
4.32 +0.10
[.170 +.004]
5
11.63
[.458]
ITEM
1
2
3
4
5
CUSTOMER-REPLACEABLE PARTS
PART NUMBER
DESCRIPTION
318432-1
318430-1
318431-1
318429-1
679231-1
INDENTER, Wire
ANVIL, Wire
INDENTER, Insulation
ANVIL, Insulation
PIN, Die Retaining
Figure 7
47.62
[1.88]
QTY PER
ASSEMBLY
1
1
1
1
4
Rev B
Tyco Electronics Corporation
5 of 5