408-4218 Datasheet, PDF (1/5 Pages) Tyco Electronics – PRO–CRIMPER III Hand Crimping Tool Assembly

PRO-CRIMPER* III Hand Crimping
Tool Assembly 318450-1 with
Die Assembly 318450-2
Instruction Sheet
408-4218
01 MAY 09 Rev B
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
Die Assembly
318450-2
Stationary
Jaw
Back of Tool
(Wire Side)
PRO-CRIMPER III Hand Crimping
Tool Frame 354940-1 (408-9930)
Moving
Jaw
Ratchet
Adjustment
Wheel
The PRO-CRIMPER III Hand Crimping Tool is a Commercial" grade tool and
is designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate 114 application specification, but may not comply with other
feature parameters of the specification. Tyco Electronics offers a variety of
tools to satisfy your performance requirements. For additional information,
contact the Tooling Assistance Center at 1-800-722-1111.
Figure 1
Stationary
Handle
Moving
Handle
1. INTRODUCTION
PRO–CRIMPER III Hand Crimping Tool Assembly
318450–1 consists of Die Assembly 318450–2 and
PRO–CRIMPER III Hand Crimping Tool Frame
354940–1. The hand tool assembly is used to crimp
COAXICON* 50–Ohm RF Series BNC and TNC
Commercial Connectors 227079–[ ], 414168–[ ],
414171–3, and 414173–[ ] onto various sizes of RG/U
cable.
For connector assembly and cable stripping
procedures, refer to the instructions packaged with
the connector. For additional information on the hand
tool frame, refer to Instruction Sheet 408–9930. Read
these instructions thoroughly before using the hand
tool assembly.
NOTE
i
Dimensions on this sheet are in millimeters
[with inches in brackets]. Figures are not drawn
to scale.
2. DESCRIPTION (Figures 1 and 2)
The hand tool assembly features a tool frame with a
stationary jaw and handle, a moving jaw, a moving
handle, and an adjustable ratchet that ensures full
connector crimping.
The tool frame holds a die assembly with two
crimping chambers. The die assembly features a wire
anvil, an insulation anvil, a wire indenter, and an
insulation indenter. Die retaining pins and die retaining
screws are used to position and secure the dies in the
tool frame.
E2009 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 5
LOC B