408-4105 Datasheet, PDF (5/6 Pages) Tyco Electronics – Adapt Various Crimping Dies For Use with 626 Pneumatic Tooling Assemblies

Straight Action Crimpers 217200- [ ]
408- 4105
3. Remove two retaining rings securing the two
groove pins at the top of the crimper housing (on
either side of the plastic switch), then remove the
groove pins.
NOTE
i
The groove pins secure the yoke, and it may be
necessary to hold the yoke in place while
removing the groove pins. When the groove pins
are removed, the yoke will be pushed out of the
housing by the two internal springs (if not
previously removed).
4. Remove the shoulder screw which secures the
plastic switch to the internal die holder and remove
the plastic switch.
5. Remove the four shoulder cap screws which
secure the two outer housings to the center
housing, then remove the outer housing.
6.2. Assembly (Refer to Figure 4)
1. Properly position the die holder assembly in the
center housing.
NOTE
i
If the optional spring (item 13, Figure 5) is to be
installed, refer to Section 5, OPTION FOR
OPERATING CRIMPER WITH NORMALLY
CLOSED DIES, to install spring. Then proceed to
Step 2 to complete assembly.
2. Re--install the outer housing and secure with the
four shoulder cap screws. DO NOT tighten the
screws.
3. Install the two springs (item 18, Figure 5) in the
top end cavities of the housing.
4. Install the yoke into top of housing and, after
aligning the groove pin holes in the yoke with the
holes in the housing, install the groove pins and
secure with retaining rings.
NOTE
i
It may be necessary to hold the yoke in place
while installing the groove pins. If groove pins
cannot be fully inserted through the housing,
loosen the four shoulder cap screws (installed in
Step 2) to provide more freedom of movement of
the outer housing.
5. Position the plastic switch so that the protruding
slotted spring pin fits into the groove on the bottom
side of the switch. Then slide the switch to align its
mounting hole with the hole in the die holder.
6. Insert the shoulder screw through the plastic
switch into the hole in the die holder and tighten
the screw.
7. Tighten the four shoulder cap screws.
8. Using a bench vice, press the two slotted spring
pins back into the housing.
7. REPLACEMENT AND REPAIR
Customer--replaceable parts are provided in Figure 5.
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Order replacement parts through
your Representative, or call 1--800--526--5142, or
send a facsimile of your purchase order to
717--986--7605 or write to:
CUSTOMER SERVICE (038--035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105--3608
For customer repair service, call 1--800--526--5136.
8. REVISION SUMMARY
Revisions to this instruction sheet include:
S Added “Original Instructions” to page 1
S Removed Proper Use Guidelines (tools are not
manually operated)
S Corrected Step 3 of Paragraph 6.2 (changed
item 19 to 18)
Rev C
Tyco Electronics Corporation
5 of 6