408-4105 Datasheet, PDF (2/6 Pages) Tyco Electronics – Adapt Various Crimping Dies For Use with 626 Pneumatic Tooling Assemblies

Straight Action Crimpers 217200- [ ]
408- 4105
assembly (including the cam) on the pneumatic tool.
After the tool holder assembly has been installed,
proceed as follows:
DANGER
To prevent personal injury, ALWAYS disconnect
the main air supply and electrical supply (if
applicable) of the pneumatic tool before installing
or removing the straight action crimper.
DANGER
DO NOT operate the pneumatic tool without the
straight action crimper and the proper die
assembly installed. After straight action crimper is
installed, make sure that the quick pins are
FULLY tightened to avoid personal injury and
damage to the tool.
1. Remove the quick pins from the tool holder
assembly.
2. Slide the crimper into the tool holder assembly,
aligning the threaded holes of the crimper with the
threaded quick pin holes of the tool holder
assembly.
3. After the crimper is properly aligned in the tool
holder assembly, insert and tighten the quick pins.
NOTE
i
Use Loctite 242 removable threadlocker, or
equivalent, to prevent the quick pins from
loosening.
Indenter
Die
Anvil
Die
Ejector
Die Holder of Crimper
Figure 2
Position of Tool Holder
Assembly for Die Installation
Dies Installed
in Die Holder
of Crimper
NOTE
i
Removal is the reverse of installation.
3.2. Die Assembly
DANGER
To prevent personal injury, ALWAYS disconnect
the main air supply and electrical supply (if
applicable) of the pneumatic tool before installing
or removing dies.
DANGER
DO NOT operate pneumatic tool without the
straight action crimper and proper die assembly
installed. After straight action crimper and
crimping dies has been installed, make sure that
the quick pins are FULLY tightened to avoid
personal injury and damage to the tool.
1. Assemble the anvil (stationary) die to the
indenter (movable) die as shown in Figure 2. The
anvil is identifiable by the chamfers and the ejector.
2. Position tool holder assembly as shown in
Figure 3, and install the die assembly.
3. Secure the die assembly in the die holder
assembly with the die holding screws. See
Figure 3.
Loctite is a trademark of Henkel Corporation.
Die Holding Screws
Figure 3
4. With the dies closed, tighten the die holding
screws.
5. Connect the pneumatic tool to an adequate air
supply (between 620 and 690 kPa [90 and
100 psi]. For specific information on air line
requirements and air hose installation, refer to
409--5862.
NOTE
i
Removal is the reverse of installation.
2 of 6
Tyco Electronics Corporation
Rev C