English
Language : 

408-4105 Datasheet, PDF (1/6 Pages) Tyco Electronics – Adapt Various Crimping Dies For Use with 626 Pneumatic Tooling Assemblies
Tool Holder Assembly
189928- 1
Straight Action Crimpers 217200- [ ]
(Adapt Various Crimping Dies
For Use with 626 Pneumatic Tooling Assemblies)
Instruction Sheet
408- 4105
19 MAR 10 Rev C
Quick Pin (Qty: 4)
Straight Action Crimper
217200- 1 (Dies Normally Open)
217200- 2 (Dies Normally Closed)
Die Assembly (Typ)
Figure 1
1. INTRODUCTION
Straight Action Crimpers 217200--[ ] are designed to
be used with the tool holder assembly shown in
Figure 1 and accept various crimping dies to adapt
them for use with 626 pneumatic tooling assemblies.
For information concerning the setup and operation of
the pneumatic tool, refer to Customer Manual
409--5862.
NOTE
i
Dimensions in this instruction sheet are in metric
units [with U.S. customary units in brackets].
Figures and illustrations are for reference only
and are not drawn to scale.
This instruction sheet provides:
— installation and removal of the straight action
crimper from the tool holder assembly
— crimping die installation and removal from the
straight action crimper
2. DESCRIPTION (Figure 1)
The straight action crimper facilitates the use of
various crimping dies and connects to the tool holder
assembly of the pneumatic tool to provide the
necessary straight line motion of the crimping dies
when the pneumatic tool is actuated. When actuated,
a cam extends through the tool holder into the
crimper, contacting an internal spring--loaded die
holder mechanism. The other end of this mechanism
is directly connected to the movable die and, as the
cam pushes against the mechanism, the movable die
moves in a straight line and bottoms against the
stationary die. When the cam of the pneumatic tool
retracts, the force is removed from the movable die
and the spring--loaded mechanism returns to its
starting position.
The crimping dies may also be opened and closed
manually by using the plastic slide switch, which is
coupled to the movable die and the spring--loaded
mechanism via a screw. The slide switch therefore
permits opening and closing of the crimping dies for
insertion and removal of the terminal or splice.
— maintenance, inspection, and repair information
for the straight action crimper
Reasons for reissue of this instruction sheet are
provided in Section 7, REVISION SUMMARY.
3. INSTALLATION AND REMOVAL (Figure 1)
3.1. Straight Action Crimper
Before installing the straight action crimper, refer to
409--5862 for instructions on installing the tool holder
E2010 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products names, logos, or company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 6
LOC B