|
408-4031 Datasheet, PDF (5/5 Pages) Tyco Electronics – PRO–CRIMPER III Hand Tool Assembly | |||
|
◁ |
PRO-CRIMPER III Hand Crimping Tool Assembly 58548-1
408-4031
Screwdriver
Ratchet
Adjustment
Wheel
10. REPLACEMENT
Customerâreplaceable parts are shown in Figure 1.
Available separately, PROâCRIMPER III Hand
Crimping Tool Repair Kit 679221â1 includes a
replacement nut and a variety of pins, rings, screws,
and springs. If the dies are damaged or worn
excessively, they must be replaced. Order the repair
kit and replaceable parts through your Tyco
Electronics representative, or call 1â800â526â5142,
or send a facsimile of your purchase order to
1â717â986â7605, or write to:
CUSTOMER SERVICE (38â35)
TYCO ELECTRONICS
PO BOX 3608
HARRISBURG PA 17105â3608
Lockscrew
(Typ)
Figure 5
9. VISUAL INSPECTION
The crimping dies should be inspected on a regular
basis to ensure that they have not become worn or
damaged. Inspect the crimp sections for flattened,
chipped, worn, or broken areas. If damage or
abnormal wear is evident, the tool must be replaced.
See Section 10, REPLACEMENT.
11.REVISION SUMMARY
Since the previous release of this instruction sheet,
the following changes were made:
S The new TE logo was applied; and
S PROâCRIMPER II was changed to
PROâCRIMPER III throughout.
Rev B
Tyco Electronics Corporation
5 of 5
|