408-4031 Datasheet, PDF (1/5 Pages) Tyco Electronics – PRO–CRIMPER III Hand Tool Assembly

PRO-CRIMPER* III Hand Crimping
Tool Assembly 58548-1
with Die Assembly 58548-2
Instruction Sheet
408-4031
28 APR 09 Rev B
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
Locator
Assembly
(Supplied with
Die Assembly)
Front of Tool
(Locator Side)
Stationary Jaw
Back of Tool
(Wire Side)
Pivot Pin
Die
Assembly
Moving Jaw
PRO-CRIMPER III Hand Crimping
Tool Frame 35494-1 (See
instruction sheet 408-9930)
Ratchet
Adjustment
Wheel
Stationary
Handle
Moving Handle
The PRO-CRIMPER III Hand Crimping Tool Assembly is a Commercial" grade tool
and is designed primarily for field installation, repair, maintenance work, or prototyping
in industrial, commercial, or institutional applications. Product crimped with this tool will
meet the crimp height requirement for hand tools in the appropriate 114 application
specification, but may not comply with other feature parameters of the specification.
Tyco Electronics offers a variety of tools to satisfy your performance requirements. For
additional information, contact the Technical Assistance Center at 1-800-722-1111.
Die Assembly
Part Number
{ Locator Assembly
Part Number
} ^Contact
Family
Size
(AWG)
Wire
Insulation Diameter
(mm [In.])
Strip Length
(mm [In.])
58548-2
58516-1
56El and
MTEl Series
26-22
20
1.1 to 1.7
[.043 to .067]
1.9 [ .075] max
3.2 to 3.7
[.126to .146]
{
Supplied with the die assembly. Also available separately.
} Contact the Product Information Center (below) for specific contact part numbers.
1. INTRODUCTION
Figure 1
any contacts.
PRO–CRIMPER III Hand Tool Assembly 58548–1
consists of Die Assembly 58548–2 and
PRO–CRIMPER III Hand Tool Frame 354940–1. The
die assembly consists of crimping dies and a locator
assembly.
Read these instructions thoroughly before crimping
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
Reasons for reissue are provided in Section 11,
REVISION SUMMARY.
E2009 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 5
LOC B