408-4031 Datasheet, PDF (4/5 Pages) Tyco Electronics – PRO–CRIMPER III Hand Tool Assembly

PRO-CRIMPER III Hand Crimping Tool Assembly 58548-1
408-4031
CAUTION
Make sure that both sides of the insulation barrel
Position
are started evenly into the crimping section. Do
Point on
!
NOT attempt to crimp an improperly positioned
contact.
Center of
Wire Barrel
Opposite
4. Hold the contact in position and squeeze the
Seam
tool handles together until ratchet engages
sufficiently to hold the contact in position. Do NOT
Modified
A"
deform insulation barrel or wire barrel.
Anvil
5. Insert stripped wire into contact insulation and
wire barrels until it is butted against the wire stop,
as shown in Figure 3.
6. Holding the wire in place, squeeze tool handles
together until ratchet releases. Allow tool handles
to open and remove crimped contact.
WIRE SIZE
AWG (MAX)
22
CRIMP SECTION
(WIRE SIZE MARKING)
CRIMP HEIGHT
DIM. (A) AND
TOLERANCE (+)
26-22
" .74
" [.029
.05
.002]
NOTE
i
The crimped contact may stick in the crimping
area, but the contact can be easily removed by
pushing downward on the top of the locator (see
Figure 3).
7. Check the contact’s crimp height as described in
Section 6, CRIMP HEIGHT INSPECTION. If
necessary, adjust the crimp height as described in
Section 7, CRIMP HEIGHT ADJUSTMENT.
6. CRIMP HEIGHT INSPECTION
This inspection requires the use of a micrometer with
a modified anvil.
NOTE
i
Tyco Electronics does not manufature or market
these gages. However, TE recommends the
modified micrometer (Crimp Height
Comparator RS–1019–5LP).
Proceed as follows:
1. Refer to Figure 4 and select a wire (maximum
size) for each crimp section listed.
2. Using a crimp height comparator, measure the
wire barrel crimp height as shown in Figure 4. If the
crimp height conforms to that shown in the table,
the tool is considered dimensionally correct. If not,
the tool must be adjusted. Refer to Section 7,
CRIMP HEIGHT ADJUSTMENT.
3. Refer to Section 5, CRIMPING PROCEDURE,
and crimp the contact(s) accordingly.
20
20
" .89
" [.035
.05
.002]
Figure 4
7. CRIMP HEIGHT ADJUSTMENT (Figure 5)
1. Remove the lockscrew from the ratchet
adjustment wheel.
2. With a screwdriver, adjust the ratchet wheel
from the locator side of the tool.
3. Observe the ratchet adjustment wheel. If a
tighter crimp is required, rotate the adjustment
wheel COUNTERCLOCKWISE to a
higher–numbered setting. If a looser crimp is
required, rotate the adjustment wheel
CLOCKWISE to a lower–numbered setting.
4. Replace the lockscrew.
5. Make a sample crimp and measure the crimp
height. If the dimension is acceptable, replace and
secure the lockscrew. If the dimension is
unacceptable, continue to adjust the ratchet, and
again measure a sample crimp.
8. MAINTENANCE
Ensure that the tool and dies are clean by wiping
them with a clean, soft cloth. Remove any debris with
a clean, soft brush. Do not use objects that could
damage the tool. When not in use, keep handles
closed to prevent objects from becoming lodged in
the crimping dies, and store in a clean, dry area.
4 of 5
Tyco Electronics Corporation
Rev B