408-10266 Datasheet, PDF (5/6 Pages) Tyco Electronics – Insert the shank of the nest into the yoke and tighten the set screw.

PIDG Terminal Crimping Die 2063361-1
Wire Barrel Die
GO Dimension
Closure Configurations
408-10266
NO-GO Dimension
Insulation Barrel Die
Closure Configurations
GO Dimension
50.8 [2.000] Min. Typ
NO-GO Dimension
DIE SET
2063361-1
6.35 [.250] Typ
W"
WIRE BARREL CRIMP CHAMBER
INSULATION BARREL CRIMP CHAMBER
GO
NO-GO
GO
NO-GO
WIDTH (W)
4.293-4.300
[.1690-.1693]
4.442-4.445
[.1749-.1750]
1.626-1.633
[.0640-.0643]
2.131-2.134
[.0839-.0840]
4.34 [.171] Max.
Figure 5
Inspection of Wire Barrel Crimping Dies (Detail A)
Inspection of Insulation Barrel Crimping Dies (Detail B)
Wire Barrel Dies
Bottomed, but Not
Under Pressure
Adjustment Spacers
in No. 3 Position
Adjustment Spacers
in No. 1 Position
Insulation
Dies
Wire Barrel Gage Must Pass
Through the Insulation Crimp
Die Closure to Enter Wire
Barrel Crimp Die Closure
GO" Gage Must Pass Completely Through Die Closure
GO" Gage Must Pass Completely Through Die Closure
NO-GO" Gage May Enter Partially, but Must
Not Pass Completely Through the Die Closure
Figure 6
NO-GO" Gage May Enter Partially, but Must
Not Pass Completely Through the Die Closure
Rev A
Tyco Electronics Corporation
5 of 6