English
Language : 

108-5246 Datasheet, PDF (5/21 Pages) Tyco Electronics – This specification covers the requirements for product performance
Product Specification
108-5246
項目
Para.
3.5.5
試験項目
Test Items
温度上昇対電流
規格値
Requirements
規定電流を通電して、温度上昇
は30 °C以下
試験方法
Procedures
通電による温度上昇を測定する
こと。
3.5.5 Temperature Rising VS
Current
3.5.6 耐湿性(定常状態)
3.5.6 Humidity, Steady State
3.5.7 耐熱性
3.5.7 Heat Resistivity
3.5.8 熱衝撃
3.5.8 Thermal Shock
30 °C Max. under loaded
rating current.
環境的性能
Environmental Requirements
総合抵抗(ローレベル)
20mΩ最大(試験後)
絶縁抵抗:100MΩ以上(終期値)
Termination Resistance
(Low Level)(Final)
20 mΩ max.
Insulation Resistance(Final)
100MΩ max.
総合抵抗(ローレベル)
20 mΩ 最大(試験後)
Termination Resistance
(Low level)(Final)
20 mΩ Max.
総合抵抗(ローレベル)
20 mΩ 最大(試験後)
Termination Resistance
(Low level)(Final)
20 mΩ Max.
Fig.2 (続き)
Fig.2(To be continued)
Measure temperature rising by
energized current.
嵌合したコネクタを相対湿度90
~95%、温度40±2℃の定常状態
に500時間さらすこと。
MIL-STD202、試験法103,条件C
Subject mated connetors to
steady state humidity at 40℃
and 90-95% R.H. for 500 hours.
MIL-STD-202, METHOD 103,
Condition C.
嵌合したコネクタを温度85±2°C
の試験環境下に500時間さらすこ
と。
MIL-STD-202、試験法108条件C
Subject mated connectors to
heat resistivity at 85±2°Cfor
500 hours,per
MIL-STD-202,METHOD 108,
Condition C
嵌合したコネクタを
-55 °C / 30 分、+85 °C / 30 分
を 1 サイクルとし、25サイクル
さらすこと。
MIL-STD-202、試験法107条件A-1
Subject mated connectors to 25
cycles between -55°C and +85 °C
for 30 minutes each.
MIL-STD-202,METHOD 107,
Condition A-1
Rev. L
5 of 21