408-8980 Datasheet, PDF (4/8 Pages) Tyco Electronics – These instructions cover the installation and use of the kits listed in the table in Figure 1.

Electronic Applicator Counter Assembly Kit(s)
408-8980
Counter
Mounting
Bracket
Ring
Magnet
Grooved Pin
Retaining Ring
Oval Head
Screw
Counter
Bracket
To install the kit, proceed as follows:
1. Disconnect the machine power and air supply.
2. Remove the air feed assembly by removing the
3/8 inch (0.37 inch) air feed mounting screw.
3. Remove the retaining ring and grooved pin from
the air cylinder clevis and discard it.
4. Install the retaining rings, ring magnet, and new
grooved pin on the cylinder clevis. See Figure 8.
Electronic
Applicato
Counter
Cylinder
Clevis
Grooved
Pin
Retaining
Ring
Figure 6
The kits can be used on Tyco Electronics HDM Air
Feed Applicators. See Figure 7 for counter assembly
mounting of end–feed type and side–feed type air
feed applicators.
Retaining
Ring
Ring Magnet
Figure 8
5. Reinstall the air feed assembly using the 3/8
inch (0.37 inch) air feed mounting screw.
6. Assemble the counter to the counter mounting
bracket with the supplied oval head screws. See
Figure 9.
7. Loosely install (finger tight) the counter
mounting bracket to the counter bracket using the
supplied washers and socket head cap screws.
See Figure 9.
Socket Head Cap
Screw(s)
Counter Installed on End-Feed Air Feed Type Applicators
Counter
Mounting
Bracket
Oval Head Screw(s)
Counter
Bracket
Counter Installed on Side-Feed Type Air Feed Applicators
Figure 7
Electronic Applicator
Counter
Figure 9
8. Reconnect the air supply.
9. Extend the feed finger to the forward position.
10. Install the air feed counter bracket to the
applicator housing using the supplied socket head
4 of 8
Tyco Electronics Corporation
Rev E