408-8980 Datasheet, PDF (1/8 Pages) Tyco Electronics – These instructions cover the installation and use of the kits listed in the table in Figure 1.

Electronic Applicator Counter Assembly Kit(s)
Instruction Sheet
408-8980
10 SEP 07 Rev E
Pushbutton
Infrared Communication Port
Display
Left-Side
Reed Switch
Location
Right-Side Reed
Switch Location
PART
NUMBER
DESCRIPTION
1804300-1
Electronic Applicator Counter Assembly
1804313-1
Electronic Applicator Counter Kits used with HDM Mechanical Feed Applicators (inch)
1804312-1
Electronic Applicator Counter Kits used with HDI Mechanical Feed Applicators (metric)
1804314-1
Electronic Applicator Counter Kits used with HDM Air Feed Applicators
1804315-1
Electronic Applicator Counter Kits used with Tab-Lok Terminal Mechanical Feed Applicators
Figure 1
1. INTRODUCTION
These instructions cover the installation and use of
the kits listed in the table in Figure 1.
infrared communication port. This port is located in
the upper right hand corner on the front of the
counter. The counter implements the IrDA®
Standards for communication.
The counter, when properly installed, will count the
number of applicator cycles. This “total count” can be
used to determine when applicator inspection and
maintenance should be performed.
When the counter is used in conjunction with the
Electronic Applicator Counter Software, the number of
cycles for individual tooling can be tracked and
maintenance data can be logged to a file on a
personal computer.
DANGER
To avoid personal injury, replace the counter
immediately if the plastic case becomes cracked.
Although the counter has been sealed, cracks or
leaks could expose the internal battery to
flammable liquid resulting in the possibility of fire,
or explosion. DO NOT SUBMERGE THE
COUNTER IN A FLAMMABLE LIQUID.
3. INSTALLATION
Refer to Customer Manual 409–10063 for more
information on this software.
Reason for revision may be found in Section 6,
REVISION SUMMARY.
2. DESCRIPTION
The counter (Figure 1) is battery powered with a
minimum expected operating life of 10 years. There
are two reed switches inside the counter. One located
on the back left side; the other on the back right. The
ring magnet is installed so it actuates one of the reed
switches each time the applicator cycles.
NOTE
i
Before beginning the installation, you will need to
be familiar with the counter's operation. Refer to
Paragraph 4.
Refer to the specific type of installation procedure for
your application.
3.1. Installation of the Electronic Applicator Counter to
HDM and HDI Mechanical Feed Applicators
NOTE
i
Refer to the appropriate applicator instructions
sheet for specific applicator adjustments and
maintenance.
The counter counts each cycle. The total number of
cycles recorded is displayed on the counter’s display.
A single button on the counter activates the display
and is used to scroll though various modes and
change settings. The counter also has a wireless
The kit (Figure 2) includes the electronic applicator
counter, counter mounting bracket, ring magnet,
adjustment screw, feed rod guide, and hardware for
mounting the counter and ring magnet to the
applicator.
E2007 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 8
LOC B