408-4485 Datasheet, PDF (4/5 Pages) Tyco Electronics – Double Action Hand Tool

DAHT Adapter Assembly 1213563- 1
408- 4485
4.2. Periodic Inspection
Regular inspections should be performed by
quality--control personnel. A record of scheduled
inspections should remain with the adapter or be
supplied to supervisory personnel responsible for the
for the adapter. Though recommendations call for at
least one inspection a month, the frequency should
be based on amount of use, working conditions,
operator training and skill, and your established
company policies. These inspections should include
the following:
1. Remove all lubrication and accumulated film by
immersing the adapter in a suitable commercial
degreaser that will not affect paint or plastic.
2. Make certain all components are in place. If
replacements are necessary, refer to Section 5,
REPLACEMENT AND REPAIR.
3. Check all bearing surfaces for wear. Replace
worn parts.
available lubricant. Lubricate according to the
following schedule:
Adapter used in daily production—lubricate daily
Adapter used daily (occasional)—lubricate weekly
Adapter used weekly—lubricate monthly
5. REPLACEMENT AND REPAIR
Replacement parts and recommended spare parts
are listed in Figure 4. The recommended spare parts
should be stocked for immediate replacement.
Replacement parts can be ordered from, or when
repair is necessary, return adapter (along with a
written description of the problem) to:
CUSTOMER SERVICE (38--35)
TYCO ELECTRONICS
PO BOX 3608
HARRISBURG, PA 17105--3608
For customer repair service, call 1--800--526--5136.
4.3. Lubrication
Lubricate all pins, pivot points, and bearing surfaces
with a high quality grease. It is recommended using
Dow Corning Molykote paste, which is a commercially
6. REVISION SUMMARY
Revisions to this instruction sheet include:
S Added “Original Instructions” to page 1
Dow Corning and Molykote are registered trademarks of Dow Corning Corporation.
4 of 5
Tyco Electronics Corporation
Rev B