408-4485 Datasheet, PDF (3/5 Pages) Tyco Electronics – Double Action Hand Tool

DAHT Adapter Assembly 1213563- 1
Adapter Assembly
Crimp Head
(Installed)
Pneumatic Tool
408- 4485
Setscrew
Adapter
Cam
Piston
Rod
Friction
Ring
Locking Ring
Stop Ring
Figure 3
4. Properly align the adapter with the cam and
push the adapter onto the pneumatic tool so that it
passes over the friction ring of the pneumatic tool.
5. Slide the locking ring toward the adapter until it
butts against the stop ring of the pneumatic tool.
Then turn the locking ring clockwise to engage
threads on the bottom of the adapter. Tighten the
locking ring to fully secure the adapter.
NOTE
i
When the adapter is properly installed, the
locking ring should be butted against the stop
ring and threads of the adapter should not be
visible. If not properly installed, check that correct
combination of cam and adapter was used and
that they are aligned properly.
6. Rotate the adapter one full turn in each direction
and note that the locking ring rotates with the
adapter.
DANGER ^{To avoid personal injury, periodically check that}
the locking ring is tightly securing the adapter.
7. Connect the pneumatic tool to an adequate
air supply (between 620 and 690 kPa [90 and
100 psi]). For specific information on air line
requirements and air hose installation, refer to
409--5862.
8. Removal is the reverse of installation.
4. MAINTENANCE AND INSPECTION
A maintenance and inspection program should be
performed periodically to ensure dependable and
uniform terminations.
DANGER
To avoid personal injury, ALWAYS disconnect the
main air supply and electrical supply (if
applicable) of the pneumatic tool before
performing maintenance or inspection.
4.1. Daily Maintenance
Each operator must be responsible for the following
steps of daily maintenance:
1. Remove dust, moisture, and other contaminants
with a clean, soft brush, or a lint--free cloth. DO
NOT use objects that could damage the adapter.
2. Make sure that all pins, rings, and other
components are in place and secure.
3. Make certain all surfaces are protected with a
thin coat of any good SAE 20 motor oil. DO NOT
oil excessively.
4. When the adapter assembly is not in use, store
it in a clean, dry area.
SAE is a trademark of SAE International Corporation.
Rev B
Tyco Electronics Corporation
3 of 5