408-4485 Datasheet, PDF (1/5 Pages) Tyco Electronics – Double Action Hand Tool

Double Action Hand Tool (DAHT)
Adapter Assembly 1213563- 1
Instruction Sheet
408- 4485
(For Use With 626 Pneumatic Tooling Assemblies) 17 MAR 10 Rev B
Typical DAHT
Crimp Head (Ref)
Mounting Holes
Setscrew
Clevis
Adapter Cavity
Adapter
Cam
Adapter Assembly
Clevis
Quick Pins
(Supplied with
Adapter Assembly)
Figure 1
1. INTRODUCTION
DAHT Adapter Assembly 1213563--1 is designed to
accept the crimp head from any DAHT to adapt the
crimp head for use with 626 pneumatic tooling
assemblies. DAHTs are available from Tyco
Electronics. For information concerning the setup and
operation of the pneumatic tool, refer to Customer
Manual 409--5862.
This instruction sheet provides:
— recommended procedures for crimp head
removal from the hand tool
— crimp head installation into the adapter
— installation and removal of the cam and adapter
from the pneumatic tool
— maintenance, inspection, and repair information
for the adapter
For wire preparation and crimping procedure, and
crimp head maintenance, inspection, and repair, refer
to the associated instruction sheet.
Read these instructions thoroughly before
proceeding.
NOTE
i
Dimensions are in millimeters [with inch
equivalents in brackets]. Figures and illustrations
are for identification only and are not drawn to
scale.
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
2. DESCRIPTION
The adapter assembly facilitates the connection of the
crimp head (typical shown in Figure 1) to the
pneumatic tool and provides the necessary motion of
the crimp head jaws when the pneumatic tool is
actuated. When the tool is actuated, the cam extends
into the adapter, contacting the crimp head jaws.
When the cam retracts, the force is removed from the
jaws and they return to their starting position.
The jaws may be opened and closed manually by
simultaneously squeezing the two opposing clevises,
which are coupled to the jaws. The quick pins secure
the crimp head to the adapter.
E2010 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products names, logos, or company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 5
LOC B