408-2453 Datasheet, PDF (4/5 Pages) Tyco Electronics – Remove protective dust caps from both quick connect/disconnect couplers

DYNA-CRIMP Hydraulic Crimping Head 69066
408-2453
13. Turn the guide set screw (11) clockwise into
the slot in the ram to prevent the ram from turning.
Be sure that the screw does not prevent the ram
from moving freely.
14. Install the guide lock screw (10) securely
against the guide set screw (11).
15. Tighten the cylinder head assembly and install
and tighten the set screw (9).
16. To install the crimping head, refer to Section 3,
CRIMPING HEAD INSTALLATION.
7. REPLACEMENT AND REPAIR
Customer–replaceable parts are listed in Figure 5. A
complete inventory can be stocked and controlled to
prevent lost time when replacement of parts is
necessary. Order replacement parts through your
Tyco Electronics Representative, or call
1–800–526–5142, or send a facsimile of your
purchase order to 1–717–986–7605, or write to:
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
Tools may also be returned for evaluation and repair.
For tool repair service, contact a Tyco Electronics
Representative at 1–800–526–5136.
8. REVISION SUMMARY
Revisions to this document include:
S Updated document to corporate requirements
S New format
S Changed title
S Changed superceded part numbers in
Section1, INTRODUCTION; CAUTION in
Paragraph 3.3; and Paragraph 6.4.2.
S Deleted obsolete instruction sheet in NOTE in
Section 3, CRIMPING HEAD INSTALLATION
12c
10 ₁₁
9
12
4 of 5
12d
5
12c
12b
12e
12a
8
4
Figure 5 (contd)
Tyco Electronics Corporation
1
13
7
6
2
Rev B