408-1662 Datasheet, PDF (4/8 Pages) Tyco Electronics – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools.

in tool. Insert female die holding pin. See
Figure 5.
408-1662
4. Push die set up with a small screwdriver or
drift pin just enough to permit female die to be
pulled out of tool.
5. Remove male die and insert die holding pin
back into tool.
2.6. Wire Stripping And Crimping Procedures
A. Wire Stripping
1. Strip shielded wire as shown in Figure 7.
Figure 5
2.4. Die Removal Hand Tool No. 59500
1. Remove female die holding pin.
2. Close handles until male die holding screw is
visible. See Figure 6.
3. Turn male die holding screw slot in a vertical
position. See Figure 6.
4. Push die set up with a small screwdriver or
drift pin just enough to permit female die to be
pulled out of tool.
5. Remove male die and insert die holding pin
back into tool.
Figure 6
2.5. Die Removal Pneumatic Tool No. 69270·1 Mod. 2
1. Remove female die holding pin.
2. Depress take-up lever until male die holding
screw is visible. See Figure 6.
3. With take-up lever depressed, turn male die
holding screw slot in a vertical position. See
Figure 6.
Rev A
Figure 7
2. Strip ground wire to dimensions given in Figure
8.
Ferrule
Number
327192
323930
thru
323934
327137
thru
327141
Recommended Ground
No. of
Wires
Max. Ins
Dia
One # 24
.063
Two # 24
.065
One # 22
.068
One # 20
.078
One # 22
.078
Two # 22
.068
One # 18
One # 20
Two # 20
One # 22
No Limit
on Insul
Diameter
Two # 22
Strip
Length
1/4 Inch
Min.
7/16 Inch
Min
Figure 8
B. Crimping Procedures
1. Place ferrule on shielded wire as shown in
Figure 9. Flare the braid so that it will pass over
and around support sleeve of ferrule.
4 of 8
LOC B