408-9917 Datasheet, PDF (3/4 Pages) Tyco Electronics – PRO-CRIMPER* III Hand

PRO- CRIMPER III Hand Crimping Tool Assembly 58519- 1
408- 9917
Flange on
Strain Relief
Outer
Crimp Ring
Fibers
Figure 3
5.3. Measuring Die Opening
The die assembly will perform correctly as long as:
(1) the product specified is correct for the application,
(2) the specific die assembly is used, (3) the die
assembly has been measured to ensure that the
openings are correct, and (4) the tool has been
adjusted correctly. Figure 4 provides information on
die openings.
1. Remove the lockscrew from the ratchet
adjustment wheel.
2. With a screwdriver, adjust the ratchet wheel
from the opposite side of the tool.
3. Observe the ratchet adjustment wheel. If a
tighter crimp is required, rotate the adjustment
wheel COUNTERCLOCKWISE to a
higher--numbered setting. If a looser crimp is
required, rotate the adjustment wheel
CLOCKWISE to a lower--numbered setting.
4. Replace the lockscrew.
5. Make a sample crimp and measure the crimp
height. If the crimp is acceptable, replace and
secure the lockscrew. If the dimension is
unacceptable, continue to adjust the ratchet, and
again measure a sample crimp.
Screwdriver
Lockscrew
(Typ)
A
(REF)
B
(REF)
Ratchet
Adjustment
Wheel
Figure 5
Die Closure Dimensions (+ .10 mm [+ .004 In.])
A
B
5.44 mm [.214 in.]
8.53 mm [.336 in.]
Figure 4
5.4. Ratchet Adjustment (Figure 5)
The tool frame assembly ratchet mechanism features
an adjustment wheel with numbered settings. If the
crimp is not acceptable, adjust the ratchet as follows:
6. REPLACEMENT
Crimping Die Assembly 58510--1 was inspected
before shipment. Tyco Electronics recommends that
the dies be inspected immediately upon arrival at your
facility to ensure that the dies have not been
damaged during shipment.
Available separately, PRO--CRIMPER III Hand
Crimping Tool Repair Kit 679221--1 includes a
replacement nut and a variety of pins, rings, screws,
and springs.
If the dies are damaged or worn excessively, they
must be replaced.
Rev B
Tyco Electronics Corporation
3 of 4