408-9917 Datasheet, PDF (1/4 Pages) Tyco Electronics – PRO-CRIMPER* III Hand

PRO- CRIMPER* III Hand
Crimping Tool Assembly 58519- 1
with Die Assembly 58510- 1
Instruction Sheet
408- 9917
22 JAN 10 Rev B
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Indenter Die
Stationary Jaw
Movable Jaw
Pivot Pin
Ratchet
Adjustment
Screw
Anvil Die
Crimping Die
Assembly 58510- 1
Emergency
Ratchet
Release
Ratchet
Adjustment
Wheel
Die Retaining
Screws
The PRO- CRIMPER III Hand Crimping Tool is a “Commercial” grade hand tool
and is designed primarily for field installation, repair, maintenance work,
or prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in the
appropriate 114 application specification, but may not comply with other feature
parameters of the specification. Tyco Electtronics offers a variety of tools to
satisfy your performance requirements. For additional information, contact the
Tooling Assistance Center at 1- 800- 722- 1111.
PRO- CRIMPER III Hand Crimping
Tool Frame Assembly 58532- [ ]
Figure 1
1. INTRODUCTION
This instruction sheet provides application and
maintenance procedures for Crimping Die Assembly
58510--1. See Figure 1. When used in
PRO--CRIMPER III Hand Crimping Tool Frame
Assembly 58532--[ ] the die assembly crimps
Fixed--Shroud Duplex fiber--optic connectors with
base part numbers 501780 and 502015, and FSD
Breakout Kit Assembly 502020.
Frame Assembly 58532--1, refer to instruction sheet
408--4020.
Read these and all referenced materials before using
the die assembly.
Reasons for reissue are in Section 7, REVISION
SUMMARY.
2. DESCRIPTION
The die assembly and frame assembly together form
PRO--CRIMPER III Hand Crimping Tool Assembly
58519--1. The die assembly can be purchased
separately, or purchased with the hand tool assembly.
For connector assembly procedures, refer to
instruction sheet 408--9373 (FSD Connectors) or
408--9469 (FSD Breakout Kit Assembly). For
information concerning the use and maintenance of
The die assembly features an indenter die and an
anvil die. When closed, the dies form two crimping
chambers, which crimp the crimp ring of the
connector onto the connector strain relief and the
cable strength members. The larger crimping
chamber is used to crimp FSD connectors. Both
chambers are used for the breakout kit assembly: the
larger to crimp duplex crimp rings and the smaller to
crimp simplex crimp rings. Each die is held in the tool
jaws with a single screw. See Figure 2.
E2010 Tyco Electronics Corporation, Harrisburg, PA TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All International Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 4
LOC B