408-9917 Datasheet, PDF (2/4 Pages) Tyco Electronics – PRO-CRIMPER* III Hand

PRO- CRIMPER III Hand Crimping Tool Assembly 58519- 1
Stationary Jaw
Indenter Die
408- 9917
Die- Retaining
Screws
Anvil Die
Movable
Jaw
Figure 2
Ratchet
3. DIE INSTALLATION (Figure 2)
1. Close the tool handles until the ratchet releases;
then allow the tool handles to open FULLY.
2. Install anvil die in the movable jaw of the tool
frame. Align the die with the retaining screw hole;
then secure die with the die--retaining screw. Do
NOT fully tighten.
5. MAINTENANCE/INSPECTION
5.1. Maintenance
1. Remove dust, moisture, and other contaminants
with a clean, soft brush, or a clean, soft, lint--free
cloth. Do NOT use any objects that could damage
the dies or tool.
3. Install indenter die in the stationary jaw of the
tool frame. Slowly close the tool handles, allowing
the dies to align themselves. When dies are
properly aligned, securely tighten both screws with
the appropriate hex wrench.
2. Make sure that the proper die--retaining screws
are properly secured.
3. When the dies are not in use, store them in a
clean, dry area.
4. CRIMPING PROCEDURE (Figure 3)
Prepare connector and cable according to the
instructions packaged with the connector, and
proceed as follows:
1. Close the tool handles until the ratchet releases;
then allow the tool handles to open FULLY.
2. Place the strain relief assembly (with the outer
crimp ring in place) in the appropriate crimping
chamber so that the flange of the strain relief rests
against the sides of the die. See Figure 3.
3. Close the tool handles until the ratchet releases;
then open the tool handles to remove the crimped
connector.
4. Store the tool with the tool handles closed to
prevent objects from becoming lodged within the
jaws.
5.2. Inspection
1. Remove all lubrication and accumulated film
from the dies by immersing the dies in a suitable
commercial degreaser.
2. Make certain that all die--retaining screws and
die components are properly secured.
3. Inspect the crimping surfaces for flattened,
chipped, worn, or cracked areas. If damage is
evident, the dies must be replaced. Refer to
Section 6, REPLACEMENT.
2 of 4
Tyco Electronics Corporation
Rev B