408-10267 Datasheet, PDF (2/3 Pages) Tyco Electronics – Undercarpet PRO–CRIMPER III Hand Tool Assembly

Undercarpet PRO-CRIMPER III Hand Tool Assembly 91392-1
408-10267
Tap Connector
Refer to Instruction Sheet 408-3127
152.4 [6.00]
3.18 [.125]
Splice Connector
Refer to Instruction Sheet 408-3128
50.8 [2.00]
Figure 2
Tap Connector
152.4 [6.00]
CAUTION
!
Before starting crimping, refer to the instruction
sheet packaged with the tap and splice
connectors for preparation procedure and
assembly sequence. The applicable sheets are
referenced in Figure 2. Failure to do so could
prevent sealing of insulation patches.
2. Hold the tool so that the flat side of the head is
parallel with the floor. See Figure 3.
3. Gently lift the cable and straddle the tool jaws
with between the conductor and the connector.
Refer to Figure 3.
4. Squeeze the tool handles together until one
handle bottoms on the handle stop.
5. Allow the handles to open FULLY, the tool from
the connector.
6. Repeat Steps 2 through 5 as necessary for one
side of the cable.
3.18 [.125]
4. MAINTENANCE AND INSPECTION
4.1. Maintenance
Ensure that the tool frame and die are clean by wiping
them with a clean, soft cloth. Remove any debris with
a clean, soft brush. Do not use objects that could
damage any components. When not in use, keep tool
handles closed to prevent objects from becoming
lodged in the die and moving jaw, and store in a
clean, dry area.
Splice Connector
2 of 3
Figure 3
Tyco Electronics Corporation
Rev A