408-10267 Datasheet, PDF (1/3 Pages) Tyco Electronics – Undercarpet PRO–CRIMPER III Hand Tool Assembly

Undercarpet PRO-CRIMPER* III
Hand Tool Assembly 91392-1
Instruction Sheet
408-10267
12 FEB 09 Rev A
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
Stationary
Jaw
Anvil Die
Head
Pivot Pin
Frame
Moving
Jaw
Ratchet Wheel
(Permanently Set to
Position 7)
Handle Stop
Stationary
Handle
The PRO-CRIMPER III Hand Tool is a Commercial" grade tool and is
designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate Application Specification (114-series), but may not comply
with other feature parameters of the specification. A variety of tools are offered
to satisfy your performance requirements. For additional information, contact
the Tooling Assistance Center at 1-800-722-1111.
Moving Handle
PRODUCT FAMILY
Undercarpet Connector
POWER CABLE SIZE
(AWG)
10-12
CONNECTOR
TAP
SPLICE
553455-2
553454-1
Figure 1
1. INTRODUCTION
2. DESCRIPTION (Figure 1)
Undercarpet PRO–CRIMPER III Hand Tool Assembly
91392–1 is used to crimp the connectors listed in
Figure 1. Read these instructions thoroughly before
using the tool assembly.
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures and
illustrations are for reference only and are not
drawn to scale.
The tool assembly consists of a frame and anvil die.
The frame features a stationary jaw and handle, a
moving jaw and handle, a handle stop, and a ratchet
that ensures full crimping. The stationary jaw holds
the anvil die. A die retaining screw is used to secure
the die. When closed, the die and moving jaw forms a
crimping chamber.
3. CRIMPING PROCEDURE
Refer to Figure 1, and select cable of the specified
size and connector for the type of application, and
proceed as follows:
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
1. Separate the conductors of the cable along the
perforations to the dimensions given in Figure 2.
E2009 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 3
LOC B