1-601967-1 Datasheet, PDF (14/17 Pages) Tyco Electronics – Application Tooling for Screw-Machine Contacts

408- 7516
3. TOOLING ASSEMBLY
3.1. Installing Positioner
Refer to Figure 4, and proceed as follows:
1. Squeeze the tool handles together, then allow
the handles to FULLY open.
CAUTION
!
The tool handles must be fully opened when
installing the positioner; otherwise, damage to
the tool will occur.
2. Insert the post of the positioner into the hole in
the back of the tool. Make sure that the bayonet
pin enters the slot in the retainer ring of the tool.
Outer
Rim
Data
Plate
Installing Positioner
Bayonet
Pin
Post
Safety
Clip
Selector Knob
and Dial
Retainer Ring
(Hidden)
Positioner
Installed
Ratchet
Back of Tool
refer to the data plate on the positioner. Pull the
selector knob and turn to the proper setting.
CAUTION
!
The tool handles must be fully opened when
changing the positioner selector setting;
otherwise, damage to the tool will occur.
3.2. Installing Turret Head
Refer to Figure 5, and proceed as follows:
1. Squeeze the tool handles together, then allow
the handles to FULLY open.
CAUTION
!
The tool handles must be fully opened when
installing the positioner; otherwise, damage to
the tool will occur.
2. Depress the turret trigger to release the turret
from the index position (the turret should be
extended).
Installing Turret Head
Positioner
Turret Trigger
Turret in Locked
Position
Back of
Turret Head
Turret
Extended
Data
Plate
Index
Mark
Socket Head Cap
Screw (2 Places)
Retainer Ring
(Hidden)
Turret Head
Installed
Tool Handles
Figure 4
Selector Knob
and Dial
3. Firmly grip the outer rim of the positioner and
push until the spring inside the positioner is
depressed, then rotate the positioner clockwise
until it stops.
4. Insert the tool safety clip into the retainer ring to
lock the positioner in place.
5. Determine the selector setting according to the
contact size and wire size listed in Figure 3 (or
Back of Tool
Tool Handles
Figure 5
14 of 17
Rev E