MA4SW510B-1_16 Datasheet, PDF (4/7 Pages) M/A-COM Technology Solutions, Inc. – Broad Bandwidth Specified up to 18 GHz

MA4SW510B-1
HMIC™ Silicon SP5T PIN Diode Switch
with Integrated Bias Network
Rev. V4
Operation of the MA4SW510B-1 PIN Switch
Operation of the HMIC Series of PIN switches is achieved by the simultaneous application of negative DC current
to the low loss port and positive DC current to the remaining isolated switching ports per the Driver Connections
table below. The control currents should be supplied by constant current sources. For insertion loss, -10 mA bias
results in approximately -2 V, and for Isolation,+10 mA yields approximately +0.9 V at the respective bias nodes.
The backside area of the die is the RF and DC return ground plane.
Typical Bias Network
J1 Input Common Port
DC Bias
J6
J2
J5
J4
J3
Typical Driver Connections
DC Control Current (mA)
B2
B3
B4
B5
-10
+10
+10
+10
+10
-10
+10
+10
+10
+10
-10
+10
+10
+10
+10
-10
+10
+10
+10
+10
RF Output States
B6
J1-J2
J1-J3
J1-J4
J1-J5
J1-J6
+10
low loss Isolation Isolation Isolation Isolation
+10
Isolation low loss Isolation Isolation Isolation
+10
Isolation Isolation low loss Isolation Isolation
+10
Isolation Isolation Isolation low loss Isolation
-10
Isolation Isolation Isolation Isolation low loss
4
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
https://www.macom.com/support