M02061_17 Datasheet, PDF (34/45 Pages) M/A-COM Technology Solutions, Inc. – 3.3 or 5 Volt Laser Driver

M02061-12/-21
3.3 or 5 Volt Laser Driver
Rev V6
The DISDLY pin is used in conjunction with the DIS pin to control bias current enable time. In normal operation the
DISDLY pin should be connected to ground. In this case, each time DIS transitions from high to low the bias current
will be enabled by the “slow-start” circuitry (enable time of less than 1 ms with a C_APC = 2.2 nF).
For burst mode operation a capacitor C is added to the DISDLY pin, the slow-start circuitry is disabled for
approximately T = 3 * 10⁶ (sec/F) * C (F) following the DIS high transition (see figure 8). If the part is enabled (DIS
transitions low) during this time the bias and modulation current will quickly return to within 90% of their final value
(in less than 500ns). If DIS transitions low after the DISDLY time the slow-start circuitry will engage and the bias
current will not return to its final value for approximately 1ms (depending on the C_APC capacitor value).
34
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
http://www.macom.com/support