M02015 Datasheet, PDF(23/29 Page) M/A-COM Technology Solutions, Inc. – Low Power CMOS Transimpedance Amplifier with Rx Pwr Mon Output and AGC for Fiber

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

M02015 Datasheet, PDF (23/29 Pages) M/A-COM Technology Solutions, Inc. – Low Power CMOS Transimpedance Amplifier with Rx Pwr Mon Output and AGC for Fiber

◁

M02015

Low Power CMOS Transimpedance Amplifier with Rx Pwr Mon Output and AGC for Fiber

Optic Networks up to 2.5 Gbps

Rev V6

Figure 4-3. Typical Layout Diagram with Photodiode Mounted on TO-Can base (5 pin TO-Can)

GND

DOUT

1nF

DOUTB

470pF

VCC

MON

Notes:

Typical application inside of a 5 lead TO-Can.

Only one of the VCC pads and one of the GND pads need to be connected (though in noisy environments two or

more GND pads connected may improve performance). The backside must be connected to the lowest

potential, usually ground, with conductive epoxy or a similar die attach material. If a monitor output is not

required then a 4 lead TO-Can may be used.

4.4

Treatment of PINK

PINK requires bypassing to ground with a 470 pF capacitor when powering a photo diode. If PINK is not used to

bias the photo diode, then it is not necessary to bypass an unused PINK.

M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.

Visit www.macom.com for additional data sheets and product information.

For further information and support please visit:

http://www.macom.com/support

▷